DIN 463

Tab Washers with Long and Short Tab at Right Angles

English 1974
0.000
DIN
Detailed Information

Technical conditions of delivery according to DIN 522

Download File
(Log in to download spec.)

Check out other specifications

ISO
ISO 1207
1992
English

Slotted cheese head screws – Product grade A

This International Standard specifies the characteristics of slotted cheese head screws of product grade A and with threads from M1,6 to M10 inclusive. If, in special cases, specifications oth [...]
DIN
DIN 431
2000
English

Pipe nuts with thread as in ISO 228-1

This standard specifies dimensions and technical delivery conditions for sizes G 1/8 to G 6 (hexagon and octagon) pipe nuts with thread as in ISO 228-1 and of product grades B and C.
DIN EN
DIN EN 1652
1998
English

Copper and copper alloys – Plate, sheet, strip and circles for general purposes – English version of DIN EN 1652

This European Standard specifies the composition, property requirements and tolerances on dimensions and form for copper and copper alloy plate, sheet, strip and circles for general purposes. [...]
ASTM
ASTM F912
2004
English

ALLOY STEEL SOCKET SET SCREWS

1.1 This specification covers the requirements for quenched and tempered alloy steel socket-set screws (SSS) 0.060 through 2.000-in. sizes having hardnesses 45 to 53 HRC. 1.2 These set screws [...]
ASTM
Abstract of ASTM F436
2000
English

HARDENED STEEL WASHERS

This specification covers the chemical, mechanical, and dimensional requirements for hardened steel washers for use with fasteners having nominal thread diameters of 1/4 through 4 in. These was [...]
ASTM
ASTM F1941M
2005
English

Standard Specification for Electrodeposited Coatings on Threaded Fasteners [Metric]

1.1 This specification covers application, performance and dimensional requirements for electrodeposited coatings on threaded fasteners with metric screw threads. It specifies coating thickness [...]
DIN
DIN 50021
1988
English

Salt spray testing

This standard specifies the requirements which corrosion testing apparatuses and corrosive agents must meet in salt spray testing, the aim being to enable identical conditions to be reproduced [...]
DIN
DIN 1480
1975
English

Turnbuckles – Forged (Open Type)

Material: Steel of at least 330 N/mm² (≈34 kp/mm²) tensile strength Steel of higher strengths or specified materials by agreement.
DIN
DIN 7971
1970
English

Pan Head Tapping Screws with Slot

Bracketed nominal diameters should be avoided wherever possible. Normally these tapping screws are made in the sizes for which weight details are given. It is not practicable to make the sizes [...]