Check out other specifications
1997
English
Standard Specification for Carbon and Alloy Steel Nuts [Metric]
1.1 This specification covers chemical and mechanical requirements for eight property classes of hex and hex-flange carbon and alloy steel nuts for general structural and mechanical uses on bol [...]
1956
English
Taper Key Torque Transmission – Gib-head Parallel Keys – Dimensions and Application
No figures tor permissible variations of tapers on keys and in hub keyways have so tar been laid down. If, in special cases, certain prescribed permissible variations must be observed, these mu [...]
2000
English
STUDS, BOLTS, SCREWS AND NUTS FOR APPLICATIONS WHERE A HIGH DEGREE OF RELIABILITY IS REQUIRED
This specification covers standard studs, hex cap screws, and heavy hex bolts in nominal standard diameters of 1/4 inch to 4 inches, nuts in nominal standard diameters of 1/4 inch to 3 inches, [...]
2008
English
SERRATED HEX FLANGE LOCKNUTS 90,000 psi (INCH SERIES)
This Standard covers the general, dimensional, and mechanical performance requirements for low strength carbon steel, case hardened, regular and large serrated flange locknuts (inch series), re [...]
1998
English
Limit gauges for unified screw threads
This Japanese Industrial Standard specifies the limit gauges to be used for the dimensional inspection of metric screw threads specified in JIS B 0210 and JIS B 0212 (hereafter referred to as “ [...]
1981
English
Bright round steel – Dimensions Permissible deviations – according to ISO tolerance zone h9
This standard applies to bright round steel of nominal diameters from 1 to 150 mm, made of the steels listed in clause 5. Details as to finish and lengths to be delivered are given in clause 6.
1996
English
Slotted head screws
This Japanese Industrial Standard specifies the steel slotted head screws (hereafter, referred to as “steel screws") , stainless steel slotted head screws (hereafter referred to as “stainless s [...]