DIN 562

Square thin nuts Product grade B

English 1987
0.000
DIN
Detailed Information

This standard specifies requirements for M1,6 to M10 square thin nuts assigned to product grade B.
If, in special cases, nuts are to comply with specifications other than those given in this standard, e.g. regarding property class, these shall be selected in accordance with the relevant standards.

Download File
(Log in to download spec.)

Check out other specifications

NASM
NASM 35333
2003
English

WASHER, LOCK, FLAT-INTERNAL TOOTH

MATERIAL: Carbon Steel, Grade 1050 to 1064. hardness 40 to 50 HRC or equivalent. Corrosion-Resistant Steel, Composition 410. Corrosion-resistant Steel, 300 series (UNS S300XX), hardness 35-43HR [...]
JIS
JIS B 1041
1993
English

Fasteners—Surface discontinuities— Part 1 : Bolts, screws and studs for general requirements

This Standard establishes limits for various types of surface discontinuities on bolts, screws and studs for general requirements. It applies to bolts, screws and studs with — nominal thread d [...]
ISO
ISO 263
1973
English

ISO inch screw threads – General plan and selection for screws, bolts and nuts – Diameter range 0.06 to 6 in

This International Standard tabulates ISO inch screw threads {except for pipe threads) having the basic profile for triangular screw threads specified in ISO 68, ISO general purpose screw threa [...]
DIN
DIN 6907
1990
English

Serrated lock washers with external teeth for screw and washer assemblies

Serrated lock washers as specified in this standard are intended tor use with screw and washer assemblies as specified in DIN 6900 Part 4. Serrated lock washers are mainly designed to provide e [...]
IFI
IFI-126
2008
English

BREAK MANDREL CLOSED END BLIND RIVETS

This standard establishes the dimensional, mechanical, and performance requirements of inch series break mandrel closed end blind rivets suitable for use in joining the component parts of an as [...]
ISO
ISO 7721-2
1990
English

Countersunk flat head screws – Part 2: Penetration depth of cross recesses

This part of ISO 7721 specifies the penetration depth of cross recesses of countersunk flat head screws for the two series 1 and 2 (deep and shallow, respectively).
ISO
ISO 3269
2000
English

Fasteners — Acceptance inspection

1.1 This International Standard specifies the acceptance inspection procedure that the purchaser of fasteners must follow in order to determine whether a lot of fasteners will be accepted or re [...]
SAE
SAE J531
2020
English

Automotive Pipe, Filler, and Drain Plugs

This SAE Standard includes complete general and dimensional specifications for those types of pipe, filler, and drain plugs (shown in Figures 1 to 6 and Tables 1 to 4) commonly used in automoti [...]
JIS
JIS B 1087
2000
English

Blind rivets — Mechanical testing

This Standard specifies the methods of mechanical testing execute under the ambient temperature of 10 °C to 35 °C of blind rivets (hereafter referred as “rivets”) including: — shear test (see c [...]