This specification covers the requirements for stainless steel nuts 0.25 to 1.50 in., inclusive, in nominal diameter in a number of alloys in common use and intended for service applications requiring general corrosion resistance.

This standard is intended to ensure that all drawings prepared to date In which general tolerances have been specified on the basis of DIN 7168 will remain intelligible and be interpreted correctly, and also to inform the user of this standard that, for all new designs, tolerances are to be speci...

IFI-115 is a standard developed through the procedures of Industrial Fasteners Institute. IFI-115 was first published in 1970 and modestly revised and reissued in 1986 and 2002.

This International Standard specifies: ⎯ requirements for studs and ceramic ferrules for arc stud welding; ⎯ dimensions, materials, mechanical properties and, when required, conditions of evaluation of conformity.

This Japanese Industrial Standard specifies flat head bolts made of steel, hereafter referred to as "steel bolts", flat head bolts made of stainless steel, hereafter referred to as "stainless steel bolts" and flat head bolts made of brass, hereafter referred to as "brass bolts" for general use.

This Japanese Industrial Standard specifies dimensions and positions of split pin holes to be provided at threaded portion of hexagon head bolts, studs, etc., and of wire holes to be provided at heads of hexagon head bolts. Further, in cases where concerning split pin hole and wire hole, this St...