This standard specifies requirements for M1,6 to M10 square thin nuts assigned to product grade B. If, in special cases, nuts are to comply with specifications other than those given in this standard, e.g. regarding property class, these shall be selected in accordance with the relevant standards.

This Japanese Industrial Standard specifies self drilling tapping screws of steel made (hereafter referred to as “steel drilling tapping screws”) and those of martensitic stainless steel made (hereafter referred to as “stainless steel drilling tapping screws”) for general use.

For connection with DIN 616 and ISO 464, see Explanations. This Standard specifies the dimensions of snap rings required for securing bearing with ring groove according to DIN 616, diameter series 0, 2, 3 and 4.

This standard specifies a system of designation for bolts, screws, studs and nuts (‘fasteners’, for short), and also gives supplementary order designations for special features and finishes of such fasteners (e.g type of thread, thread end, slotting of bolt head or nut, hardness). Where no specif...

This standard specifies dimensions and technical delivery conditions for square taper washers for use in structural bolting of steel I sections using bolts up to property class 5.6.

This Japanese Industrial Standard specifies the slotted head wood screws (hereafter referred to as "wood screws") made of steel, stainless steel and brass for general use.