Check out other specifications
2015
English
High-strength structural bolting assemblies for preloading Part 1: General requirements
This European Standard specifies the general requirements for bolt/nut/washer(s) assemblies for high-strength structural bolting, which are suitable for preloading. The intended use of bolting assemblies in accordance with this European Standard is structural metallic works. NOTE 1 High […]
1993
English
HARDENED STEEL WASHERS [METRIC]
1.1 This specification covers the chemical, mechanical, and dimensional requirements for metric hardened steel washers for use with fasteners having nominal thread diameters M12 through M100. These washers are intended for general purpose mechanical and structural use with bolts, nuts, st […]
1973
English
Driving Elements – Bushes for Plain Bearings – according to DIN 502, DIN 503 and DIN 504
A long-standing desire of users to see the interchangeability of bearing bushes assured when they have to be replaced has now been fulfilled by the standardization of these bushes. The outside diameters of the bushes could not however be scheduled in agreement with DIN 1850 Part 1 (August […]
2007
English
TEST PROCEDURE FOR THE PERFORMANCE OF ADHESIVE COATED PREVAILING-TORQUE SCREWS
This standard establishes a conformance test procedure for the performance of adhesive coated prevailing-torque screws, in nominal screw sizes No. 4 thru 3/4 in. Torque values given in this standard are conformance requirements for adhesive coated prevailing-torque screws and apply only […]
1974
English
Clip Bolts
Clip bolts according to DIN 6378 are clamping components which are used in the manufacture of workpieces. They form part of fixtures which are in immediate contact with workpieces for machining and which must be firmly connected to them. To tighten the fixture the clamping clips of seve […]