ISO 7092
Plain washers – Small series – Product grade A
English
2000
0.000
Detailed Information
This International Standard specifies the characteristics of small-series, product-grade-A plain washers in the 200 HV and 300 HV hardness classes and of nominal sizes (nominal thread diameters) ranging from 1,6 mm to 36 mm inclusive.
Download File
(Log in to download spec.)
Check out other specifications
2001
English
NONFERROUS BOLTS, HEX CAP SCREWS, AND STUDS FOR GENERAL USE
1.1 This specification covers the requirements for commercial wrought nonferrous bolts, hex cap screws, and studs 0.250 to 1.500 in. inclusive in diameter manufactured from a number of alloys in common use and intended for general service applications. 1.2 Applicable nuts for use with bol […]
1983
English
Square weld nuts
The May 1970 edition of DIN 928 specified property class 8 with the suffix "weldable" for weld nuts. In the meantime, the proof loads for nuts in international specifications have been raised (see DIN ISO 898 Part 2), the nut heights also being recalculated (see DIN 970). It turned out t […]
2001
English
NONFERROUS NUTS FOR GENERAL USE
1.1 This specification covers the requirements for commercial wrought nonferrous nuts 0.250 to 1.500 in. inclusive in diameter in a number of alloys in common use and intended for general service applications. 1.2 Applicable bolts, cap screws, and studs for use with nuts covered by this s […]
1995
English
Studs – with a length of engagement equal to about 2,5 d
This standard specifies dimensions and technical delivery conditions for studs intended for use mainly in light metals of low strength. As specified in DIN 267-2, the stud end thread shall be produced to tolerance Sk6 as in DIN 13-51, unless the stud is designated Fo (‘without interferenc […]
1995
English
STANDARD TEST METHODS FOR DETERMINING THE MECHANICAL PROPERTIES OF EXTERNALLY AND INTERNALLY THREADED FASTENERS, WASHERS, AND RIVETS [METRIC]
1.1 These test methods establish procedures for conducting tests to determine the mechanical properties of metric externally and internally threaded fasteners, washers, and rivets. 1.2 Property requirements and the applicable tests for their determination are specified in individual produ […]
1990
English
Serrated lock washers with external teeth for screw and washer assemblies
Serrated lock washers as specified in this standard are intended tor use with screw and washer assemblies as specified in DIN 6900 Part 4. Serrated lock washers are mainly designed to provide electric contact between components coated with varnish, anti-corrosive agents or similar materia […]