Check out other specifications
1993
English
METRIC HEXAGON SOCKET HEAD SHOULDER SCREWS
1.1.1 This standard contains complete dimensional, mechanical, and performance requirements for Metric Series Hexagon Socket Head Shoulder Screws with nominal shoulder diameters from 6.5 mm to [...]
1993
English
METRIC SOCKET SET SCREWS
1.1.1 This standard contains complete general and dimensional requirements for metric series socket set screws of nominal sizes from 1.6 mm to 24 mm recognized as American National Standard. Al [...]
1997
English
STAINLESS STEEL METRIC BOLTS, SCREWS, AND STUDS
1.1 This specification covers the chemical and mechanical requirements for stainless steel metric bolts, screws, and studs with nominal thread diameters M1.6 through M36, and intended for use i [...]
2008
English
NYLON INSERT LOCKNUTS (INCH SERIES)
This Standard covers the complete general, dimensional, mechanical, and performance data for carbon steel, inch series nylon insert locknuts of property grades NE2, NE5, and NE8 designated as A [...]
2000
English
ALLOY STEEL BOLTING MATERIALS FOR LOW TEMPERATURE SERVICE
1.1 This specification covers alloy steel bolting materials for pressure vessels, valves, flanges. and fittings for low temperature service. The term "bolting material" as used in this specific [...]
1998
English
Fasteners—Surface discontinuities— Part 2 : Nuts
This Standard establishes limits for various types of surface discontinuities on nuts. It applies to nuts with — nominal thread diameters from 5 mm up to and including 39 mm; — product grade [...]
1990
English
Countersunk flat head screws – Part 2: Penetration depth of cross recesses
This part of ISO 7721 specifies the penetration depth of cross recesses of countersunk flat head screws for the two series 1 and 2 (deep and shallow, respectively).