ISO 8677

Cup head square neck bolts with large head – Product grade C

English 1986

0.000

Detailed Information

This International Standard specifies the characteristics of cup head square neck bolts with large head, with metric dimensions and thread sizes from M5 to M20 inclusive, of product grade C.

Download File

(Log in to download spec.)

Check out other specifications

DIN

DIN 920

1986

English

Slotted pan head screws with small head

The following amendments have been made in comparison with the August 1972 edition. a) Size M1,8 has been deleted because there is no demand for it. b) The previous design m as specified in DIN 267 Part 2, April 1968 edition, has been replaced by product grade F as specified in DIN 267 Pa […]

Custom

John Deere | JDM F21

2012

English

Fasteners, Hydraulic Connectors, Hose Fittings and Tube Assemblies — Specification for Zinc-Nickel Electroplated Coating Requirements

1.1 JDM F21 specifies the requirements for electroplated zinc nickel coating for fasteners (see note 1) or hydraulic connectors and hose fittings made of steel or of copper alloy. JDM F21 specifies coating thicknesses and other coating requirements, and gives recommendations for hydrogen […]

ASTM

ASTM F871M

1998

English

Standard Specification for Electrodeposited Coatings on Threaded Components [Metric]

1.1 This specification covers dimensional requirements for electrodeposited coating on threaded fasteners with M metric threads. It establishes a service condition classification for these fasteners and specifies coating thicknesses as well as hydrogen embrittlement relief for high-streng […]

DIN EN

DIN EN 20898-6

1992

English

Mechanical properties of fasteners – Nuts with specified proof load values – Fine pitch thread (ISO 898-6 : 1988) English version of DIN EN 20 898 Part 6

This part of ISO 898 specifies the mechanical properties of nuts with specified proof load values: - with nominal thread diameters, d, from 8 mm up to and including 39 mm; - of triangular ISO thread and with diameters and pitches according to ISO 68 and ISO 262 (fine pitch thread); - with […]

ISO

ISO 3506-1

2009

English

Mechanical properties of corrosion-resistant stainless steel fasteners — Part 1: Bolts, screws and studs

This part of ISO 3506 specifies the mechanical properties of bolts, screws and studs made of austenitic, martensitic and ferritic steel grades of corrosion-resistant stainless steels, when tested over an ambient temperature range of 10 °C to 35 °C. Properties vary at higher or lower tempe […]

DIN

DIN 315

1983

English

Wing nuts

The following amendments have been made in comparison with the December 1972 edition: a) The dimensions of the wing nuts have been altered in some respects. b) Limiting sizes have been adopted. c) Sizes M 2 to M 3,5 have been deleted. d) The technical delivery conditions have been complem […]