ISO 8992

Fasteners — General requirements for bolts, screws, studs and nuts

English 1986
0.000
ISO
Detailed Information

This International Standard specifies the general requirements for standardized bolts, screws, studs and nuts; it complements the International Standards on dimensional and tolerance requirements, and the International Standards on mechanical and functional requirements.

It is recommended that this International Standard be used also for non-standardized bolts, screws, studs and nuts.

Download File
(Log in to download spec.)

Check out other specifications

ISO
ISO 263
1973
English

ISO inch screw threads – General plan and selection for screws, bolts and nuts – Diameter range 0.06 to 6 in

This International Standard tabulates ISO inch screw threads {except for pipe threads) having the basic profile for triangular screw threads specified in ISO 68, ISO general purpose screw threa [...]
JIS
JIS B 1021
2003
English

Tolerances for fasteners — Part 1 : Bolts, screws, studs and nuts — Product grades A, B and C

This Standard specifies a selection of tolerances for bolts, screws, studs and nuts with ISO metric threads and with product grades A, B and C and for tapping screws with product grade A.
DIN
DIN 937
1983
English

Hexagon thin castle nuts (previous design)

This standard gives specifications for hexagon thin castle nuts with metric threads ranging from 6 to 52 mm nominal thread diameter, assigned to product grades A (up to and including 16 mm nomi [...]
DIN
DIN 966
1984
English

Cross recessed raised countersunk (oval) head screws

If raised countersunk oval head screws with length tabled below the stepped line are to be supplied threaded up to the head, i.e. deviating from the standard design, the letter A shall be incor [...]
DIN
DIN 7964
1990
English

Reduced shank bolts and screws with coarse thread

This standard specifies requirements for M 2,5 to M 30 bolts and screws ('bolts', for short) with various head styles and a diameter of the unthreaded portion of the shank smaller than the mino [...]
JIS
JIS B 1056
2000
English

Prevailing torque type steel hexagon nuts— Mechanical and performance properties

This Standard specifies the mechanical and performance properties for prevailing torque type steel hexagon nuts (including those with flange) when tested over an ambient temperature range of 10 [...]
DIN
DIN 653
1986
English

Knurled thin thumb screws

Where knurled thumb screws of sizes not less than M 2 shall be supplied threaded up to the head, letter A as specified in DIN 962 shall be stated in the designation (see example of designation [...]
ASTM
ASTM F788/F788M
1997
English

Standard Specification for Surface Discontinuities of Bolts, Screws, and Studs, Inch and Metric Series

1.1 This specification establishes allowable limits for the various types of surface discontinuities that may occur during the manufacture and processing of bolts, screws, and studs, including [...]
ISO
ISO 5864
1978
English

ISO inch screw threads – Allowances and tolerances

This International Standard specifies a system of allowances and tolerances for standard thread series, covering the range of diameters from 0.06 to 6 in, and pitches from 80 to 4 threads per inch.