DIN 939

Studs – with a length of engagement equal to about 1,25 d

English 1995
0.000
DIN
Detailed Information

This standard specifies dimensions and technical delivery conditions for studs intended for use mainly in cast iron. As specified in DIN 267-2, the stud end thread shall be produced to tolerance Sk6 as in DIN 13-51, unless the stud is designated Fo (‘without interference-fit thread’) or Sn4.

Download File
(Log in to download spec.)

Check out other specifications

JIS
JIS B 0253
1985
English

Gauges for taper pipe threads

This Japanese Industrial Standard specifies the taper thread gauge for pipe hereinafter referred to as the "thread gauge", to be used for the dimensional inspection of the taper external thread [...]
ASTM
ASTM F837M
1991
English

Standard Specification for Stainless Steel Socket Head Cap Screws [Metric]

1.1 This specification covers the chemical and mechanical requirements for stainless steel metric socket head cap screws (SHCS) with nominal thread M 1.6 through M 36 and intended for use in ap [...]
SAE
SAE J1237
1996
English

METRIC THREAD ROLLING SCREWS

This SAE standard covers requirements for metric thread rolling screws suitable for use in general engineering applications. Requirements for three material-process options are stated: a. Scr [...]
ASTM
Abstract of ASTM A563M
1996
English

CARBON AND ALLOY STEEL METRIC NUTS

This specification covers chemical and mechanical requirements for eight property classes of hex and hex flange carbon and alloy steel nuts for general structural and mechanical uses on bolts, [...]
DIN
DIN 432
1983
English

External tab washers (Locking tab washers)

This standard specifies requirements for external tab washers (previously known as locking tab washers), which are used in threaded fastenings. They are intended to prevent the fastening loosen [...]
ASTM
ASTM A574
2008
English

ALLOY STEEL SOCKET-HEAD CAP SCREWS

1.1 This specification covers the requirements for quenched and tempered alloy steel hexagon socket-head cap screws, 0.060 through 4 in. in diameter where high strength is required. 1.2 The va [...]
DIN
DIN 929
2000
English

Hexagon weld nuts

This standard specifies requirements for sizes M3 to M16 coarse and fine pitch thread hexagon weld nuts of product grade A, for use with bolts of property classes below 8.8 as specified in DIN [...]
DIN
DIN 74361-3
1979
English

Disc wheels for motor vehicles and trailers – Dimensions and fasteners for attachment with centring on wheel bore

This standard specifies requirements for the attachment of disc wheels with 15° tapered rims as covered in DIN 78 022, on commercial vehicles and trailers. Design-related details left unspecif [...]
ISO
ISO 4755
1983
English

Fasteners – Thread undercuts for external metric ISO threads

This International Standard lays down the form and dimensions of thread undercuts for bolts, screws and similar externally threaded products, recommended for use in those cases where an undercu [...]