Check out other specifications
2010
English
CARBON AND ALLOY STEEL NUTS FOR BOLTS FOR HIGH PRESSURE OR HIGH TEMPERATURE SERVICE, OR BOTH
1.1 This specification covers a variety of carbon, alloy, and martensitic stainless steel nuts in the size range 1/4 through 4 in. nominal. It also covers austenitic stainless steel nuts in the size range 1/4 in. nominal and above. These nuts are intended for high-pressure or high-temperature ser...
1985
English
Hexagon socket thin head cap screws with pilot recess for wrench key
This standard specifies product grade A hexagon socket thin head cap screws with pilot recess for wrench key with ISO metric screw thread from M4 up to and including M36. If, in special cases, the screws are to meet requirements other than those given in this standard, e.g.with regard to propert...
1993
English
Fasteners—Surface discontinuities— Part 1 : Bolts, screws and studs for general requirements
This Standard establishes limits for various types of surface discontinuities on bolts, screws and studs for general requirements. It applies to bolts, screws and studs with — nominal thread diameters 5 mm and larger; — product grades A and B; — property classes up to and including 10.9, unless ...
2014
English
Specification for Electroplated Zinc Coatings on Fasteners
JDM F15 specifies requirements for electroplated zinc coatings for fasteners made of steel. JDM F15 applies primarily to electroplated coatings on threaded fasteners, non-threaded fasteners, and fastener accessories such as pins and washers. JDM F15 may also be applied to other threaded parts whe...