DIN 961
Sechskantschrauben- Gewinde annähernd bis Kopf – Metrisches Feingewinde – Ausführung m und mg
German
1970
0.000
Detailed Information
Üblicherweise werden diese Schrauben in den durch Gewichtsangabe gekennzeichneten Größen hergestellt.
Technische Lieferbedingungen nach DIN 267
Download File
(Log in to download spec.)
Check out other specifications
1993
English
METRIC HEXAGON SOCKET HEAD SHOULDER SCREWS
1.1.1 This standard contains complete dimensional, mechanical, and performance requirements for Metric Series Hexagon Socket Head Shoulder Screws with nominal shoulder diameters from 6.5 mm to 25 mm recognized as American National Standard. Also included are appendices covering formulas for dimen...
1997
English
Standard Specification for Nonferrous Bolts, Hex Cap Screws, and Studs for General Use [Metric]
1.1 This specification covers the requirements for commercial wrought nonferrous bolts, hex cap screws. and studs in nominal thread diameters M6 to M36 inclusive manufactured from a number of alloys in common use and intended for general service applications. 1.2 Unless otherwise specified, nuts ...
1973
English
Knurls
Compared with the January 1940 issue of DIN 82, the standard denomination "knurl" has been adopted for all types, since the previous denomination "diamond knurling" and "negative diamond knurling" were not used consistently, and hence difficulties arose in the choice of tools. Some types of knurl...
1998
English
INSPECTION AND QUALITY ASSURANCE PLAN REQUIRING IN-PROCESS INSPECTION AND CONTROLS
This standard outlines a Quality Assurance Plan for internally and externally threaded fasteners and accessories or associated parts. Provisions are included for sampling plans, inspection frequencies, control procedures, and record keeping. The basic structure of this plan outlines the quality a...
1999
German
Blankstahlerzeugnisse – Technische Lieferbedingungen Teil 3: Automatenstähle – Deutsche Fassung EN 10277-3 : 1999
1.1 Dieser Teil von EN 10277 gilt für blanke, gerade Stäbe aus Automatenstählen Im gezogenen, geschälten oder geschliffenen Zustand. 1.2 Diese EN 10277-3 wird vervollständigt durch EN 10277-1.