DIN 1469

Grooved Pins, Half Length Grooved with Gorge

English 1978
0.000
DIN
Detailed Information

Grooved pins according to this Standard are positive or non-positive connecting elements. They are used for holding retaining rings, retaining washers, springs, etc., the grooved pin being seated firmly in the accommodating hole, for which tolerance zone H11 is recommended.

Download File
(Log in to download spec.)

Check out other specifications

DIN
DIN 261
1987
English

T-head bolts

This standard specifies M8 to M100 x 6 T-head bolts. They are designed for use in attaching components to foundations or similar structures by means of T-sIots, such as are specified in DIN 649, where T-head bolts are considered adequate detachable fasteners.
IFI
IFI-553
1999
English

METRIC DRIVE PIN BLIND RIVETS

This standard establishes the requirements for metric drive pin blind rivets suitable for use in joining the component parts of an assembly.
DIN
DIN 1157
1973
English

Decorator’s tacks

Decorator's tacks shall be made of steel (grade at manufacturer's discretion) and have a bright (bk) or blue annealed (bl g) finish.
ISO
ISO 4753
1983
English

Fasteners – Ends of parts with external metric ISO thread

This International Standard lays down the form and dimensions of ends of parts with external metric ISO thread (for example, bolt and screw ends) recommended for use, unless otherwise specified in the appropriate product standard.
DIN
DIN 71511
1975
English

Gaskets for Oval Flanges

Gaskets according to this Standard are intended for oval flanges according to DIN 71501.
DIN
DIN 6340
1987
English

Washers for clamping devices

Washers for clamping devices as specified in DIN 6340 are designed to be used for clamps as specified in DIN 6314, DIN 6315 and DIN 6316. Their dimensions have thus been harmonized with the specifications given in those standards.