DIN 965

Cross recessed countersunk flat head screws

English 1990
0.000
DIN
Detailed Information

This standard specifies requirements for M 1,6 to M 10 cross recessed countersunk head screws assigned to product grade A. See DIN 962 (or the standards referred to therein) for special screw types or finishes.

Download File
(Log in to download spec.)

Check out other specifications

ISO
ISO 885
1976
English

General purpose bolts and screws – Metric series – Radii under the head

This International Standard specifies the sizes of the radii under the head of metric series general purpose bolts and screws.
ASTM
ASTM F593
2008
English

STAINLESS STEEL BOLTS, HEX CAP SCREWS, AND STUDS

This specification covers the requirements for stainless steel bolts, hex cap screws, and studs 0.25 to 1.50 in., inclusive, in nominal diameter in a number of alloys in common use and intended for service applications requiring general corrosion resistance.
DIN
DIN 1144
1973
English

Nails for the installation of wood wool composite panels

Nails shall be made of steel (grade at manufacturer's discretion) and have a galvanized (Zn) or metallized (me) finish.
DIN
DIN 6881
1956
English

Taper Key Torque Transmission – Saddle Keys – Dimensions and Application

No figures for permissible variations of tapers on keys and in hub keyways have so far been laid down. If, in special cases, certain prescribed permissible variations must be observed, these must be agreed with the manufacturer when ordering.
DIN EN
DIN EN 28839
1991
English

Mechanical properties of fasteners – Nonferrous metal bolts, screws, studs and nuts (ISO 8839 : 1986) (English version of DIN EN 28 839)

This International Standard specifies the mechanical properties of bolts, screws, studs and nuts - with nominal thread diameters, d, from M1,6 to M39 inclusive; - with metric ISO thread in accordance with ISO 261; - made of copper and copper alloys or aluminium and aluminium alloys. It does not ...
DIN
DIN 267-24
1983
English

Fasteners – Technical delivery conditions – Property classes for nuts (Hardness classes)

This standard specifies the mechanical properties of nuts which do not have to withsand specified proof loads. The property classes specified have been classified according to minimum hardness values from which however no conclusions can be drawn with regard to the loadability and the stripping s...