DIN 2093

Dimensions and quality of conical disc springs

English 1992
0.000
DIN
Detailed Information

This standard specifies requirements for the materials, dimensions, tolerances, and permissible stresses for conical disc springs. It includes graphs showing the permissible relaxation and the endurance life of such springs, as a function of stress.

The minimum requirements specified here are intended to ensure the proper performance of conical disc springs, and may also be applied to non-standardized springs.

The three series specified here represent groups of spring sizes which have met with general acceptance in practice.

Conical disc springs are not intended to be used with bolt/nut assemblies to counteract the effect of setting (as are DIN 6796 conical spring washers, for example).

Download File
(Log in to download spec.)

Check out other specifications

DIN
DIN 6900-5
1990
English

Screw and washer assemblies – Coarse threaded screws with captive conical spring washer

This standard specifies requirements for screw and washer assemblies consisting of an M2,5 to M 12 screw with flat bearing face, assigned to property classes 8.8 up to and including 10.9, and a [...]
DIN
DIN 8195
1977
English

Design and selection of chain drives

1.1 This standard contains capacity rating charts and gives recommendations on the selection of chain drives, composed of roller chains and chain wheels conforming to DIN 8187 and DIN 8188, and [...]
ASTM
ASTM F880M
1997
English

Standard Specification for Stainless Steel Socket Set Screws [Metric]

1.1 This specification covers the requirements for austenitic grade stainless steel socket set screws (SS5), sizes M 1.6 through M 24, having Property Classes A 1-50 and A 1-70.
DIN EN
DIN EN 493
1991
English

Fasteners – Surface discontinuities – Nuts – English version of DIN EN 493: 1992

1.1 This European Standard establishes limits for various types of surface discontinuities on nuts with - nominal thread diameters from 5 up to and including 39 mm - product grades A and B - al [...]
DIN
DIN 660
1993
English

Round head rivets with nominal diameters from 1 to 8 mm

This standard specifies dimensions of steel and nonferrous metal round head rivets with nominal diameters from 1 to 8 mm.
ISO
ISO 965-1
1980
English

ISO general purpose metric screw threads – Tolerances – Part 1 : Principles and basic data

This International Standard specifies a tolerance system for screw threads conforming to ISO 261, ISO general purpose metric screw threads - General plan. The tolerance system refers to the bas [...]
DIN
DIN 964
1970
English

Slotted Raised Countersunk (Oval) Head Screws (Countersunk Heads according to ISO)

Intermediate lengths should as fer as possible be avoided. Lengths over 60 mm should be arranged in 10 mm steps. Normally these screws are manufactured in the sizes characterized by the quote [...]
IFI
IFI-117
2008
English

PULL THROUGH MANDREL BLIND RIVETS

This standard establishes the dimensional, mechanical, and performance requirements for inch series pull through mandrel blind rivets suitable for use in engineering assemblies where load trans [...]
DIN
DIN 267-1
1982
English

Fasteners – Technical delivery conditions – General requirements

This standard applies to standardized fasteners (mainly bolts, screws, nuts and similar threaded and formed parts) as finished components in the condition on delivery, in so far as no special s [...]