Check out other specifications
2004
English
Hexalobular socket head cap screws
This Standard specifies the characteristics of hexalobular socket head cap screws with thread sizes from M2 up to and including M20, of product grade A. If, in special cases, specifications other than those listed in this International Standard are required, they should be selected from existing...
1986
English
Weld studs
Weld studs are fasteners which are primarily selected because of their weldability. When determining what loadbearing capacity weld studs are to have, account shall be taken of their inherent strength, the part into which the studs are welded, and the intended function, e.g. use as components of ...
1961
English
Rod Ends and Clevis Pins
The following publications form a part of the specification to the extend specified herein. Unless otherwise indicated the latest revision of SAE publications shall apply. SAE J1010-Emission Control Hose SAE J1111-Component Nomenclature-Skidder-Grapple
1992
English
Mechanical properties of fasteners – Part 7: Torsional test and minimum torques for bolts and screws with nominal diameters 1 mm to 10 mm
This part of ISO 898 specifies a torsional test for the determination of the breaking torque of bolts and screws with nominal diameters 1 mm to 10 mm with property classes 8.8 to 12.9 in accordance with ISO 898-1. The test applies to bolts and screws with thread less than M3 for which no breaking...
1997
English
METRIC SELF-DRILLING TAPPING SCREWS
This standard covers requirements for metric steel self-drilling tapping screws suitable for use in general engineering applications. The objective of this standard is to insure that self-drilling tapping screws, by meeting the mechanical and performance requirements specified, shall drill a hol...