Check out other specifications
1986
English
Round nuts with drilled holes in one face
Round nuts with drilled holes in one face are parts generally made of steel, stainless steel or non-ferrous metals, which are designed to be used for various purposes, as for instance in electrical engineering. They can be tightened by means of a pin type face wrench as specified m DIN 3116 and a...
2005
English
Hexagon flange bolts
This Japanese Industrial Standard has been prepared based on ISO 15071 Hexagon bolts with flange—Small series—Product grade A and ISO 15072 Hexagon bolts with flange with metric fine pitch thread—Small series—Product grade A published in 1999 as the first edition by editing and integrating the co...
1987
English
Hexagon thin slotted nuts and castle nuts with metric coarse and fine pitch thread Product grades A and B
This standard specifies requirements for M6 to M52 hexagon slotted nuts and castle nuts, assigned to product grade A (up to size M16) or product grade B (for sizes above M16). If, in special cases, nuts are to comply with specifications other than those given in this standard, e.g. regarding pro...
2002
English
STRAIGHTNESS GAGING METHOD AND STRAIGHTNESS LIMITS FOR MACHINE, TAPPING, AND THREAD ROLLING SCREWS
This standard establishes a method for inspecting the out-of-straightness limits for machine, tapping, and thread rolling screws. Included are screws fully threaded or with thread lengths of at least 4D and screw lengths to and including 12 inches (D equals nominal screw diameter). For screws wit...
1996
English
SCREW AND WASHER ASSEMBLIES – SEMS
(a) This standard covers general and dimensional data pertinent to the various types of screw and captive washer assemblies, otherwise known as SEMS. The word SEMS is recognized in the United States as a generic term applicable to screw and washer assemblies. Also included in this standard are a...
