DIN 6921

Hexagon flange bolts

English 1983
0.000
DIN
Detailed Information

This standard specifies product grade A hexagon flange bolts with metric coarse screw thread or metric fine screw thread from 5 up to and including 20 mm nominal thread diameter. If, in special cases, specifications other than those listed in this standard are required, e.g. different nominal lengths or property classes, these shall be selected in accordance with the appropriate standards.

Download File
(Log in to download spec.)

Check out other specifications

DIN
DIN 6900-1
1990
English

Screw and washer assemblies – Coarse threaded screws with captive plain washer

This standard specifies requirements for screw and washer assemblies consisting of an M 2,5 to M12 screw with flat bearing face, assigned to property class 10.9 or less, and a captive plain was [...]
IFI
IFI-530
1999
English

METRIC STRUCTURAL SPLITTING SELF-PLUGGING PULL MANDREL BLIND RIVETS

This standard establishes the dimensional, mechanical, and performance requirements for metric structural splitting self-plugging pull mandrel blind rivets suitable for use in engineering assem [...]
DIN
DIN 1804
1971
English

Slotted Round Nut for Hook Spanner – ISO Metric Fine Thread

Material (strength properties): at least 5 according to DIN 267 Sheet 4 Type: w unhardened and unground h hardened to HRC 60 ± 2 with the exception of the thread, faces ground For hook wrenches [...]
ISO
ISO 888
1976
English

Bolts, screws and studs – Nominal lengths, and thread lengths for general purpose bolts

This International Standard specifies nominal lengths for bolts, screws and studs, and thread lengths for general purpose bolts.
DIN
DIN 6325
1971
German

Zylinderstifte, gehärtet – Toleranzfeld m6

Zylinderstifte nach dieser Norm werden hauptsächlich als Poßstifte für Werkzeuge, Spannzeuge und Meßzeuge verwendet.
MIL
MIL-DTL-25027H
1997
English

NUT, SELF-LOCKING, 250° F, 450° F, AND 800° F

This specification covers self-locking nuts for use in temperatures of 250° F, 450° F, and 800° F (see 6.1).
ISO
ISO 3800-1
1977
English

Threaded fasteners – Axial load fatigue testing – Part 1 : Test methods

This International Standard specifies the conditions for carrying out axial load fatigue tests on threaded fasteners.
DIN
DIN 427
1986
English

Slotted headless screws with chamfered end

This standard specifies the characteristics of M 1 to M 20 slotted headless screws with chamfered end. Where, for special applications, the screws are to meet requirements differing from those [...]
ANSI
ANSI B18.2.3.5M
1995
English

METRIC HEX BOLTS

1.1 This standard covers the complete general and dimensional data for metric hex bolts recognized as American National Standard. 1.2 The inclusion of dimensional data in this standard is not i [...]