JIS B 0208
Unified fine screw threads
English
1978
0.000
Detailed Information
This Japanese Industrial Standard specifies the basic profile, formulas and basic dimensions for unified fine screw threads used for aircrafts and other purposes of limited necessity.
Download File
(Log in to download spec.)
Check out other specifications
2002
English
TECHNICAL SUPPLY CONDITIONS FOR THREADED STEEL FASTENERS PART 2 TOLERANCES FOR FASTENERS — BOLTS, SCREWS, STUDS AND NUTS — PRODUCT GRADES A, B AND C
This part of ISO 4759 specifies a selection of tolerances for bolts, screws, studs and nuts with ISO metric threads and with product grades A, B and C and for tapping screws with product grade A. The tolerances, except tolerances for threads, are selected from the system of limits and fits speci...
2008
English
Standard Specification for General Requirements for Flat-Rolled Stainless and Heat-Resisting Steel Plate, Sheet, and Strip
1.1 This specification covers a group of general requirements that, unless otherwise specified in the purchase order or in an individual specification, shall apply to rolled steel plate, sheet, and strip, under each of the following specifications issued by ASTM: Specifications A 167, A 176, A 24...
1994
English
SURFACE DISCONTINUITIES ON BOLTS, SCREWS, AND STUDS IN FATIGUE APPLICATIONS
This SAE Recommended Practice defines, illustrates, and specifies allowable limits for various types of surface discontinuities that may occur or become apparent during the manufacture and processing of bolts, screws, and studs which are primarily intended for use in automotive assemblies subject...
2005
English
Hexagon flange bolts
This Japanese Industrial Standard has been prepared based on ISO 15071 Hexagon bolts with flange—Small series—Product grade A and ISO 15072 Hexagon bolts with flange with metric fine pitch thread—Small series—Product grade A published in 1999 as the first edition by editing and integrating the co...
1956
English
Taper Key Torque Transmission – Parallel Keys – Dimensions and Application
No figures for permissible variations of tapers on keys and in hub keyways have so far been laid down. If, in special cases, certain prescribed permissible variations must be observed, these must be agreed with the manufacturer when ordering.
2015
English
High-strength structural bolting assemblies for preloading Part 6: Plain chamfered washers
This European Standard specifies, together with EN 1 4399-1 and EN 1 4399-2, hardened and tempered chamfered plain washers with chamfer intended for bolting assemblies with large series hexagon high-strength structural bolts and nuts with thread sizes from M12 to M36 inclusive. Washers according...