DIN 78
Bolt end protrusions
English
2001
0.000
Detailed Information
This standard specifies minimum bolt end protrusions for general purpose assemblies of bolts, screws, studs and similar fasteners with ISO metric screw thread (coarse pitch thread) as in DIN 13-1 and DIN ISO 261, and hexagon nuts.
Download File
(Log in to download spec.)
Check out other specifications
2000
English
Blind rivets — Mechanical testing
This Standard specifies the methods of mechanical testing execute under the ambient temperature of 10 °C to 35 °C of blind rivets (hereafter referred as “rivets”) including: — shear test (see clause 3), — tensile test (see clause 3), — mandrel head retention capability test (see clause 4), — mand...
1999
English
METRIC PULL THROUGH MANDREL BLIND RIVETS
This standard establishes the dimensional, mechanical, and performance requirements of metric pull through mandrel blind rivets suitable for use in engineering assemblies where load transmitting capability by the rivet is a design requirement.
2003
English
Tolerances for fasteners — Part 1 : Bolts, screws, studs and nuts — Product grades A, B and C
This Standard specifies a selection of tolerances for bolts, screws, studs and nuts with ISO metric threads and with product grades A, B and C and for tapping screws with product grade A.
2006
English
SMALL SOLID RIVETS 7/16 IN. NOMINAL DIAMETER AND SMALLER
This standard covers complete general and dimensional data for those types of small solid rivets recognized as “American National Standard." All other types of small solid rivets, within the limits of the diameters contained herein, are to be considered special. Also included is an appendix cover...
1986
English
Slotted pan head screws with large head
The following amendments have been made in comparison with the August 1972 edition. a) Size M1,8 has been deleted because there is no demand for it. b) The previous design m as specified in DIN 267 Part 2, April1968 edition, has been replaced by product grade F as specified in DIN 267 Part 6 and ...
1990
English
Reduced shank bolts and screws with coarse thread
This standard specifies requirements for M 2,5 to M 30 bolts and screws ('bolts', for short) with various head styles and a diameter of the unthreaded portion of the shank smaller than the minor diameter. Although such bolts have a reduced shank, they are not waisted shank bolts. In addition to ...