DIN 7973

Raised Countersunk (Oval) Head Tapping Screws with Slot

English 1970
0.000
DIN
Detailed Information

Normally, these tapping screws are made in the sizes for which weight details are given. It is not practicable to make the sizes for which dashes appear instead of length data.

Technical conditions of delivery and material according to DIN 267 Sheet 12 (at present circulating as draft).

Download File
(Log in to download spec.)

Check out other specifications

ASTM
Abstract of ASTM B696
1991
English

COATINGS OF CADMIUM MECHANICALLY DEPOSITED ON IRON AND STEEL

1.1 General - This specification covers the requirements for a coating of cadmium mechanically deposited on metal products. The coating is provided in various thicknesses up to and including 12 [...]
ISO
ISO 7719
1983
English

Prevailing torque type all-metal hexagon nuts, style 1 – Property classes 5, 8 and 10

This International Standard specifies the characteristics of prevailing torque type all-metal hexagon nuts with thread sizes from M 5 to M 36 inclusive, in property classes 5, 8 and 10, and pro [...]
DIN
DIN 926
1986
English

Slotted set screws with full dog point

The following amendments have been made in comparison with the August 1972 edition. a) Size M1,8 has been deleted because there is no demand for it. b) The previous design m as specified in DIN [...]
DIN
DIN 601
1970
English

Hexagon Bolts without Hexagon Nut – with Hexagon Nut – Type g

This standard agrees essentially with the following ISO Recommendations issued by the International Organization for Standardization (ISO): ISO/R 272-1968 ISO/R 733-7968 ISO/R 855-1968 ISO/R 888-1968
ASME
ASME B18.1.1
2006
English

SMALL SOLID RIVETS 7/16 IN. NOMINAL DIAMETER AND SMALLER

This standard covers complete general and dimensional data for those types of small solid rivets recognized as “American National Standard." All other types of small solid rivets, within the li [...]
ASTM
ASTM A325M
1997
English

Standard Specification for High-Strength Bolts for Structural Steel Joints [Metric]

1.1.1 Type 1-Bolts made of medium-carbon steel. 1.1.2 Type 2-Bolts made from what is generally described as low-carbon martensite steel. 1.1.3 Type 3-Bolts made of steel having atmospheric corr [...]
DIN
DIN 7973
1970
English

Raised Countersunk (Oval) Head Tapping Screws with Slot

Normally, these tapping screws are made in the sizes for which weight details are given. It is not practicable to make the sizes for which dashes appear instead of length data. Technical condi [...]
DIN
DIN 7983
1990
English

Cross recessed raised countersunk head tapping screws

DIN 7504 shall apply with regard to tapping screws with drilling tip (self-drilling screws). The DIN 4000 - 2 - 1 tabular layout of article characteristics shall apply for screws as covered in [...]
ASME
ASME B18.2.8
1999
English

CLEARANCE HOLES FOR BOLTS, SCREWS, AND STUDS

This standard covers the recommended clearance hole sizes for #0 through 1.5 inch fasteners in three classes of clearance using a close-, normal-, and loose-fit category.