DIN 314

Wing nuts with edged wings

English 1999
0.000
DIN
Detailed Information

This standard specifies dimensions, designation and technical delivery conditions for M 4 to M 12 wing nuts with edged wings, of product grade C and made of malleable cast iron, steel or copper-zinc alloy.

Download File
(Log in to download spec.)

Check out other specifications

ASTM
Abstract of ASTM A325
2002
English

STRUCTURAL BOLTS, STEEL, HEAT TREATED, 120/105 KSI MINIMUM TENSILE STRENGTH

1.1 This specification covers two types of quenched and tempered steel heavy hex structural bolts having a minimum tensile strength of 120 ksi for sizes 1.0 in. and less, and 105 ksi for sizes over 1.0 to 1-1/2 in., inclusive. 1.2 The bolts are intended for use in structural connections. These co...
DIN
DIN 74361-3
1979
English

Disc wheels for motor vehicles and trailers – Dimensions and fasteners for attachment with centring on wheel bore

This standard specifies requirements for the attachment of disc wheels with 15° tapered rims as covered in DIN 78 022, on commercial vehicles and trailers. Design-related details left unspecified, such as shape of wheel disc and connection between rim and wheel disc, are to be selected as approp...
ISO
ISO 1207
1992
English

Slotted cheese head screws – Product grade A

This International Standard specifies the characteristics of slotted cheese head screws of product grade A and with threads from M1,6 to M10 inclusive. If, in special cases, specifications others than those listed in this International Standard are required, they should be selected from existing...
ASTM
Abstract of ASTM A194/A194M
2010
English

CARBON AND ALLOY STEEL NUTS FOR BOLTS FOR HIGH PRESSURE OR HIGH TEMPERATURE SERVICE, OR BOTH

1.1 This specification covers a variety of carbon, alloy, and martensitic stainless steel nuts in the size range 1/4 through 4 in. nominal. It also covers austenitic stainless steel nuts in the size range 1/4 in. nominal and above. These nuts are intended for high-pressure or high-temperature ser...
BS EN ISO
BS EN ISO 286-2
2010
English

Geometrical product specifications (GPS) — ISO code system for tolerances on linear sizes – Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts (ISO 286-2:2010)

This part of ISO 286 gives values of the limit deviations for commonly used tolerance classes for holes and shafts calculated from the tables given in ISO 286-1. This part of ISO 286 covers values for the upper limit deviations ES (for holes) and es (for shafts), and the lower limit deviations EI...
DIN
DIN 6884
1956
English

Taper Key Torque Transmission – Gib-head Parallel Keys – Dimensions and Application

No figures tor permissible variations of tapers on keys and in hub keyways have so tar been laid down. If, in special cases, certain prescribed permissible variations must be observed, these must be agreed with the manufacturer when ordering.