DIN 7982
Cross recessed countersunk head tapping screws
English
1984
0.000
Detailed Information
DIN 6901 shall apply for the designation of tapping screws with captive washer components (tapping screw assemblies).
DIN 4000 – 2 – 1 tabular layout of article characteristics shall apply for screws in accordance with this standard.
Download File
(Log in to download spec.)
Check out other specifications
1986
English
Slotted raised countersunk head screws with full dog point
The following amendments have been made in comparison with the August 1972 edition. a) Size M1,8 has been deleted because there is no demand for it. b) The previous design m as specified in DIN 267 Part 2, April1968 edition, has been replaced by product grade F as specified in DIN 267 Part 6 and ...
1983
English
External tab washers (Locking tab washers)
This standard specifies requirements for external tab washers (previously known as locking tab washers), which are used in threaded fastenings. They are intended to prevent the fastening loosening off. The washer's effectiveness depends on the design conditions of the particular case and on the l...
1983
German
Mechanische Verbindungselemente – Technische Lieferbedingungen – Muttern mit Klemmteil
Die in dieser Norm aufgeführten Festigkeitsklassen, die mechanischen und funktionellen Eigenschaften und die Prüfverfahren gelten für Muttern mit Klemmteil - mit Gewinde-Nenndurchmesser von 3 bis 39 mm - mit Metrischem ISO-Gewinde nach den Normen der Reihe DIN 13 - mit Formen nach den entsprechen...
2003
English
Tolerances for fasteners — Part 1 : Bolts, screws, studs and nuts — Product grades A, B and C
This Standard specifies a selection of tolerances for bolts, screws, studs and nuts with ISO metric threads and with product grades A, B and C and for tapping screws with product grade A.
1981
English
Parallel pins
Parallel pins in accordance with this 5tandard are designed for the fastening of two or more individual elements. A friction type connection can be achieved by the selection of suitable fits If such a connection is meant to be disconnected repeatedly, then it becomes preferable to use taper pins ...