DIN 59370
Steel Sections – Bright Square Edge Equal Angles – Dimensions, Permissible Deviations, Weights
English
1978
0.000
Detailed Information
This Standard applies to bright square edge angles with equal legs, in the dimension range specified in Table 1 and made from the steel grades quoted in Section 5.
Download File
(Log in to download spec.)
Check out other specifications
2011
English
MECHANICAL AND MATERIAL REQUIREMENTS FOR EXTERNALLY THREADED FASTENERS
This SAE standard covers the mechanical and material requirements for inch-series steel bolts, screws. studs. screws for sems, and U-bolts used in automotive and related industries in sizes to 1-1/2 in. inclusive. The term “stud" as referred to herein applies to a cylindrical rod of mode […]
1987
English
Cold reduced mild unalloyed steel strip in widths not exceeding 650mm – Technical delivery conditions
1.1 This standard applies to cold reduced flat products (strip and lengths cut from it), without coating, in widths not exceeding 650 mm and thicknesses up to 6mm, made from mild unalloyed steels as specified in table 1. The steels are suitable for forming and surface refinement, but not […]
3.01
2002
English
Threading tools—Vocabulary Part 1 : Taps
This part of JIS B 0176 specifies terms and definitions related to the taps to be used mainly for metal workings in general.
1992
English
Full-length parallel grooved pins, with pilot (ISO 8739 : 1986) English version of DIN EN 28 739
This International Standard specifies the characteristics of full-length parallel grooved pins with pilot which have three equally spaced grooves impressed longitudinally on their exterior surface and a pilot to facilitate insertion, with metric dimensions and nominal diameter, d1, from 1 […]
1999
English
Tolerances for fasteners— Part 3 : Plain washers for bolts, screws and nuts—Product grades A and C
This Japanese Industrial Standard specifies a selection of tolerances for use in the preparation of the product standards for plain washers, grades A and C, for bolts, screws and nuts with nominal thread diameters from 1 mm up to and including 150 mm. Deviations from the tolerances specif […]