DIN 59370
Steel Sections – Bright Square Edge Equal Angles – Dimensions, Permissible Deviations, Weights
English
1978
0.000
Detailed Information
This Standard applies to bright square edge angles with equal legs, in the dimension range specified in Table 1 and made from the steel grades quoted in Section 5.
Download File
(Log in to download spec.)
Check out other specifications
2001
English
ISO general purpose metric screw threads — Tolerances — Part 2: Limits of sizes for general purpose external and internal screw threads — Medium quality
This Standard specifies limits of sizes for pitch and crest diameters for ISO general purpose metric screw threads (M) conforming to JIS B 0205-3 having basic profile according to JIS B 0205-1. The limits of sizes for the tolerance quality specified are derived from the fundamental deviations an...
2010
English
WING NUTS (INCH SERIES)
This Standard covers complete general and dimensional data for nine various types and styles of wing nuts. Thumb screws and wing screws, recognized as American National Standard, are included in ASME B18.6.8. The inclusion of dimensional data in this Standard is not intended to imply that all th...
2001
English
ISO general purpose metric screw threads — Part 3: Selected sizes for screws, bolts and nuts
This Standard specifies selected sizes for screws, bolts and nuts in the diameter range from 1 mm to 64 mm of ISO general purpose metric screw threads (M) having basic profile according to JIS B 0205-1.
2000
English
HARDENED STEEL WASHERS
This specification covers the chemical, mechanical, and dimensional requirements for hardened steel washers for use with fasteners having nominal thread diameters of 1/4 through 4 in. These washers are intended for general purpose mechanical and structural use with bolts, nuts, studs, and other i...
1993
English
CHROMIUM/ZINC CORROSION PROTECTIVE COATINGS FOR FASTENERS
1.1 This specification covers the basic requirements for three grades of chromium/zinc inorganic coatings for threaded fasteners. 1.2 These coatings are applied by conventional dip-spin or dip·drain methods. 1.3 The coating process does not induce hydrogen embrittlement, providing that the fasten...