NASM 35275
SCREW, MACHINE-DRILLED FILLISTER HEAD, SLOTTED, CORROSION RESISTING STEEL, PASSIVATED, UNC-2A
English
1999
0.000
Detailed Information
DRILLED HOLE IS TO BE APPROXIMATELY AT RIGHT ANGLES TO THE SLOT AND MAY BE PERMITTED TO BREAK THROUGH THE BOTTOM OF THE SLOT. ALL SHARP EDGES SHALL BE REMOVED.

Download File
(Log in to download spec.)
Check out other specifications
2010
English
NONFERROUS BOLTS, HEX CAP SCREWS, AND STUDS FOR GENERAL USE
1.1 This specification covers the requirements for commercial wrought nonferrous bolts, hex cap screws, and studs 0.250 to 1.500 in. inclusive in diameter manufactured from a number of alloys in common use and intended for general service applications. 1.2 Applicable nuts for use with bolts, cap ...
1991
English
Fasteners – Surface discontinuities – Nuts – English version of DIN EN 493: 1992
1.1 This European Standard establishes limits for various types of surface discontinuities on nuts with - nominal thread diameters from 5 up to and including 39 mm - product grades A and B - all property classes according to EN 20898-2, ISO 898-6 and ISO 2320 unless otherwise specified In product...
2001
English
Phosphate conversion coatings of metals – Method of specifying requirements – English version of DIN EN 12476
This European Standard specifies a method of specifying requirements for phosphate conversion coatings, intended primarily for application to ferrous metals, aluminium, zinc, cadmium and their alloys (see annex A).
1997
English
Standard Specification for Nonferrous Nuts for General Use [Metric]
1.1 This specification covers the requirements for commercial wrought nonferrous nuts in nominal thread diameters M6 to M36 inclusive in a number of alloys in common use and intended for general service applications. 1.2 Applicable bolts, cap screws, and studs for use with nuts covered by this sp...
2007
English
GAGES AND GAGING FOR UNIFIED INCH SCREW THREADS
This standard provides essential specifications and dimensions for the gages used on Unified inch screw threads (UN and UNR thread form), and covers the specifications and dimensions for the thread gages and measuring equipment listed in Tables 1 and 2. (IFI Note: Same as Tables 1 and 2 of ASME B...