JIS B 0209-1
ISO general purpose metric screw threads – Tolerances – Part 1: Principles and basic data
English
2001
0.000
Detailed Information
This Standard specifies the tolerance system for ISO general purpose metric screw threads (M) conforming to JIS B 0205-2.
The tolerance system refers to the basic profile in accordance with JIS B 0205-1.
Download File
(Log in to download spec.)
Check out other specifications
1995
English
Studs – with a length of engagement equal to about 1 d
This standard specifies dimensions and technical delivery conditions for studs intended for use mainly in steel. As specified in DIN 267-2, the stud end thread shall be produced to tolerance Sk6 as in DIN 13-51, unless the stud is designated Fo (‘without interference-fit thread’) or Sn4.
1956
English
Taper Key Torque Transmission – Parallel Keys – Dimensions and Application
No figures for permissible variations of tapers on keys and in hub keyways have so far been laid down. If, in special cases, certain prescribed permissible variations must be observed, these must be agreed with the manufacturer when ordering.
2001
English
Domed cap nuts
This Japanese Industrial Standard specifies the steel domed cap nuts (hereafter referred to as “steel nuts”) , the stainless steel domed cap nuts (hereafter referred to as “stainless steel nuts”) , and the brass domed cap nuts (hereafter referred to as “brass nuts”), all for general use.
1995
English
SPRING PINS – COILED TYPE [METRIC SERIES]
Coiled spring pins shall have straight cylindrical sides with both ends chamfered. They are available in standard duty, heavy duty, and light duty to suit various design requirements. Coiled type spring pins have multiple walls, are spirally wrapped from strip stock to a diameter larger t […]
2010
English
STRUCTURAL BOLTS, STEEL, HEAT TREATED, 120/105 KSI MINIMUM TENSILE STRENGTH
1.1 This specification covers two types of quenched and tempered steel heavy hex structural bolts having a minimum tensile strength of 120 ksi for sizes 1.0 in. and less and 105 ksi for sizes over 1.0 to 1-1/2 in., inclusive. 1.2 The bolts are intended for use in structural connections. […]
2008
English
GLOSSARY OF TERMS RELATING TO BLIND RIVETS
This glossary presents preferred nomenclature and definitions of terms relating to blind rivets. It is intended that this glossary serve as a guide to users and producers to assist them toward the use of a single system of terminology for the characteristics and properties of blind rivet […]