JIS B 0209-3

ISO general purpose metric screw threads – Tolerances – Part 3: Deviations for constructional screw threads

English 2001
0.000
JIS
Detailed Information

This Standard specifies deviations for pitch and crest diameters for ISO general purpose metric screw threads (M) conforming to JIS B 0205-2 having basic profile according to JIS B 0205-1.

The deviations specified are derived from the fundamental deviations and tolerances specified in JIS B 0209-1.

Download File
(Log in to download spec.)

Check out other specifications

DIN
DIN 7973
1970
English

Raised Countersunk (Oval) Head Tapping Screws with Slot

Normally, these tapping screws are made in the sizes for which weight details are given. It is not practicable to make the sizes for which dashes appear instead of length data. Technical condi [...]
IFI
IFI-530
1999
English

METRIC STRUCTURAL SPLITTING SELF-PLUGGING PULL MANDREL BLIND RIVETS

This standard establishes the dimensional, mechanical, and performance requirements for metric structural splitting self-plugging pull mandrel blind rivets suitable for use in engineering assem [...]
ASME ANSI
ASME/ANSI B18.2.2
1999
English

SQUARE AND HEX NUTS (INCH SERIES)

1.1.1 This standard is intended to cover the complete general and dimensional data for the various types of inch series square and hex nuts recognized as "American National Standard." Also incl [...]
JIS
JIS B 1116
1980
English

Slotted head machine screws for precision instruments

This Japanese Industrial Standard specifies the steel slotted head machine screws, herein after referred to as the "steel machine screws", brass slotted head machine screws, hereinafter referre [...]
ANSI
ANSI B18.2.3.8M
1991
English

METRIC HEX LAG SCREWS

1.1 This standard covers the complete general and dimensional data for metric hex lag screws recognized as American National Standard. 1.2 The inclusion of dimensional data in this standard is [...]
ASTM
ASTM F2329
2005
English

ZINC COATING, HOT-DIP, REQUIREMENTS FOR APPLICATION TO CARBON AND ALLOY STEEL BOLTS, SCREWS, WASHERS, NUTS AND SPECIAL THREADED FASTENERS

1.1 This specification covers the requirements for hot-dip zinc coating applied to carbon steel and alloy steel bolts, screws, washers, nuts, and special threaded fasteners applied by the hot-d [...]
ISO
ISO 10683
2014
English

Fasteners — Non-electrolytically applied zinc flake coatings

This International Standard specifies requirements for non-electrolytically applied zinc flake coatings for steel fasteners. It applies to coatings: — with or without hexavalent chromium; — wit [...]
ASTM
ASTM A502
1993
English

Standard Specification for Steel Structural Rivets

1.1 This specification covers three grades of steel rivets in diameters from 1/2 to 1 1/2 in. ( 13 to 38 mm), inclusive, for structural fabricating purposes. The grades are as follows: 1.1.1 Gr [...]
DIN EN
DIN EN 20898-2
1994
English

Mechanical properties of fasteners – Nuts with coarse pitch thread and specified proof load values (ISO 898-2 : 1992) English version of DIN EN 20898 Part 2

This International Standard specifies the mechanical properties of nuts with specified proof load values when tested at room temperature (see ISO 1). Properties will vary at higher and lower te [...]