JIS B 1001
Diameter of clearance holes and counter bores for bolts and screws
English
1985
0.000
Detailed Information
This Japanese Industrial Standard specifies the diameters of clearance holes, hereinafter referred to as the “bolt hole diameters”, and the diameters of counterbores for bolts, machine screws, and the like for general use.
Download File
(Log in to download spec.)
Check out other specifications
1996
English
Slotted head screws
This Japanese Industrial Standard specifies the steel slotted head screws (hereafter, referred to as “steel screws") , stainless steel slotted head screws (hereafter referred to as “stainless s [...]
1985
English
Diameter of clearance holes and counter bores for bolts and screws
This Japanese Industrial Standard specifies the diameters of clearance holes, hereinafter referred to as the "bolt hole diameters", and the diameters of counterbores for bolts, machine screws, [...]
1987
English
Hexagon nuts with metric coarse and fine pitch thread – Product classes A and B
This standard specifies requirements for M1 to M160 hexagon nuts, assigned to product grade A (up to size M16) or product grade B (for sizes above M16). lf, in special cases, nuts are to comply [...]
1992
English
Hexagon head screws with metric fine pitch thread – Product grades A and B – (ISO 8676: 1988) – English version of DIN EN 28 676
This International Standard gives specifications for hexagon head screws with metric fine pitch thread with nominal thread diameters from 8 to 64 mm, of product grade A for nominal thread diame [...]
1996
English
CARBON AND ALLOY STEEL METRIC NUTS
This specification covers chemical and mechanical requirements for eight property classes of hex and hex flange carbon and alloy steel nuts for general structural and mechanical uses on bolts, [...]
1990
English
General rules for tightening of threaded fasteners
This Japanese Industrial Standard specifies general matters relating to significance of tightening by combination of bolt and nut, basis of tightening and representative control method. Furthe [...]
1993
English
Slotted spring-type straight pins (ISO 8752: 1987) English version of DIN EN 28 752
This International Standard specifies the characteristics of slotted spring-type straight pins with metric dimensions and nominal diameters, d1, from 1 to 50 mm Inclusive.