Clip bolts according to DIN 6378 are clamping components which are used in the manufacture of workpieces. They form part of fixtures which are in immediate contact with workpieces for machining and which must be firmly connected to them. To tighten the fixture the clamping clips of several clip...

This Japanese Industrial Standard specifies eyenuts for general lifting work of machinery (hereafter referred to as "nuts").

Normally, these screws are manufactured in the sizes for which weight details are given. If the screws are to be supplied with captive washer components, the designation must be augmented according to DIN 6900. Recesses and depth gauges according to DIN 7962.

Slotted capstan screws may be used both as fastening and adjusting screws. They are primarily designed for use in electrical engineering and may be tightened by means of a sliding tee bar where it is not possible to use a screwdriver. Locking wires are often attached to the cross holes for securi...

This standard specifies requirements for M 3 to M 8 cross recessed pan head screws assigned to product grade A. See DIN 962 (or the standards referred to therein) for special screw types or finishes. If, in special cases, screws are to comply with specifications other than those given in this sta...

1.1 This specification covers quenched and tempered steel hex cap screws, bolts, and studs having a minimum tensile strength of 120 ksi for diameters 1.0 in. and smaller; 105 ksi for diameters over 1.0 in. to 1-1/2 in.; and 90 ksi for diameters 1-3/4 in. to 3.0 in. inclusive. The term “fasteners"...