1. Scope. This standard covers double end studs of four types and in nominal thread diameters M5 thru M100. 2. Types. Type 1 - Unfinished Type 2 - Finished, Full or Undersize Body Type 3 - Finished, Full Body Type 4 - Finished, Close Body

1.1 This specification covers the requirements for quenched and tempered alloy steel hexagon socket-head cap screws, 0.060 through 4 in. in diameter where high strength is required. 1.2 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are includ...

1.1 This specification covers the requirements for quenched and tempered alloy steel hexagon socket head cap screws, 0.060 through 4 in. in diameter where high strength is required. NOTE 1 - A complete metric companion to Specification ASTM A574 has been developed - A574M; therefore no metric equ...

This standard specifies product grade A hexagon flange bolts with metric coarse screw thread or metric fine screw thread from 5 up to and including 20 mm nominal thread diameter. If, in special cases, specifications other than those listed in this standard are required, e.g. different nominal len...

Spring lock washers covered in this standard are deemed to be spring washers designed for use with bolt/nut assemblies involving fasteners of property class 5.8 or less, as specified in ISO 898 Part 1. They are intended to counteract the effect of setting which results in bolt/nut assemblies work...

This standard specifies product grade A hexagon socket thin head cap screws with ISO metric screw thread from size M3 up to and including size M 24. If, in special cases, the screws are to meet requirements other than those given in this standard, e.g. with regard to property class or material, ...