Check out other specifications
2004
English
Parallel screw thread gauges— Measuring method of gauges
This Japanese Industrial Standard specifies measuring method of screw thread plug gauges and ring gauges (hereafter referred to as “thread gauges”) among limit gauges for parallel screw threads having single-start thread with symmetrical ridge defined in JIS B 0251, JIS B 0254 or JIS B 0255 and o...
1997
English
COMPRESSIBLE-WASHER-TYPE DIRECT TENSION INDICATORS FOR USE WITH STRUCTURAL FASTENERS [METRIC]
1.1 This specification covers the requirements for compressible-washer-type direct tension indicators capable of indicating the achievement of a specified minimum bolt tension in a structural bolt. 1.2 Two types of direct tension indicators in nominal diameter sizes M16 through M36 are covered: ...
2014
English
Specification for Electroplated Zinc Coatings on Fasteners
JDM F15 specifies requirements for electroplated zinc coatings for fasteners made of steel. JDM F15 applies primarily to electroplated coatings on threaded fasteners, non-threaded fasteners, and fastener accessories such as pins and washers. JDM F15 may also be applied to other threaded parts whe...
1986
English
Tabular layouts of article characteristics for bolts, pins, rivets, and keys
This standard specifies tabular layouts, in accordance with DIN 4000 Part 1, for standardized and non-standardized bolts, pins, rivets, and keys.
1996
English
SQUARE AND HEX BOLTS AND SCREWS (INCH SERIES)
This standard covers the complete general and dimensional data for eight product types of inch series square and hex bolts and screws recognized as American National Standard. Also included are appendixes covering thread runout sleeve gages, gaging procedure for checking bolt and screw straightne...
1986
English
Slotted pan head screws with small head
The following amendments have been made in comparison with the August 1972 edition. a) Size M1,8 has been deleted because there is no demand for it. b) The previous design m as specified in DIN 267 Part 2, April 1968 edition, has been replaced by product grade F as specified in DIN 267 Part 6 and...