IFI-528
METRIC STUDS AND BENT BOLTS
English
1999
0.000
Detailed Information
1. Scope. This standard covers double end studs of four types and in nominal thread diameters M5 thru M100.
2. Types.
Type 1 – Unfinished
Type 2 – Finished, Full or Undersize Body
Type 3 – Finished, Full Body
Type 4 – Finished, Close Body
Download File
(Log in to download spec.)
Check out other specifications
2007
English
QUENCHED AND TEMPERED ALLOY STEEL BOLTS, STUDS, AND OTHER EXTERNALLY THREADED FASTENERS
This specification covers the chemical and mechanical requirements of quenched and tempered alloy steel bolts, studs, and other externally threaded fasteners 4 in. and under in diameter for application at normal atmospheric temperatures, where high strength is required and for limited app […]
1987
English
Prevailing torque type hexagon nuts with nonmetallic insert
This standard specifies requirements for M 5 to M 24 prevailing torque type hexagon nuts with nonmetallic insert, assigned to product grade A for sizes up to M 16 and product grade B for sizes over M 16. If, in special cases, nuts are to comply with specifications other than those given i […]
2000
English
Plain washers – Normal series – Product grade C
This International Standard specifies the characteristics of normal-series, product-grade-C plain washers in the 100 HV hardness class and of nominal sizes (nominal thread diameters) ranging from 1,6 mm to 64 mm inclusive. Washers of hardness class 100 HV are suitable for -hexagon bolt […]
1986
English
Slotted raised countersunk head screws with full dog point
The following amendments have been made in comparison with the August 1972 edition. a) Size M1,8 has been deleted because there is no demand for it. b) The previous design m as specified in DIN 267 Part 2, April1968 edition, has been replaced by product grade F as specified in DIN 267 Par […]
1997
English
Standard Specification for Surface Discontinuities of Nuts, Inch and Metric Series
1.1 This specification establishes allowable limits for the various types of surface discontinuities that may occur during the manufacture and processing of metric-series nuts with nominal diameters 5 mm and larger and inch-series nuts with nominal diameters 1/4 in. and larger. 1.2 The va […]
1983
English
Plain washers for metric bolts, screws and nuts – General plan
This International Standard lays down the specification for the full range of plain washers of product grades A and C for bolts, screws and nuts with thread sizes from M 1 to M 150 inclusive. This International Standard does not apply to washers for preassembled bolts and screws as far a […]