Check out other specifications
1998
English
Limit gauges for unified screw threads
This Japanese Industrial Standard specifies the limit gauges to be used for the dimensional inspection of metric screw threads specified in JIS B 0210 and JIS B 0212 (hereafter referred to as “limit gauges for screw threads”), and the gauges to be used for checking (hereafter referred to as “chec...
2009
English
THREADED RODS (INCH SERIES)
This Standard covers the complete general and dimensional data for inch series threaded rods recognized as American National Standard. Included are diameters #4 through 4 in. UNC, UNF, 8UN, and ACME in both right-and left-handed threads. At this time, there are no ISO standards for inch threaded...
1991
English
Standard Specification for Stainless Steel Socket Head Cap Screws [Metric]
1.1 This specification covers the chemical and mechanical requirements for stainless steel metric socket head cap screws (SHCS) with nominal thread M 1.6 through M 36 and intended for use in applications requiring general corrosion resistance. 1.2 Two groups of stainless steel alloys are covered,...
2000
English
Hexagon thin slotted nuts and castle nuts with metric coarse and fine pitch thread Product grades A and B
This standard specifies dimensions and technical delivery conditions for sizes M6 to M52 coarse and fine pitch thread hexagon slotted nuts and castle nuts of product grades A (up to M16) and B (M18 to M52).
1992
English
Grooved pins with countersunk head (ISO 8747 : 1986) English version of DIN EN 28 747
This International Standard specifies the characteristics of countersunk head grooved pins which have three equally spaced grooves impressed longitudinally on their exterior surface, with metric dimensions and nominal diameter, d1, from 1,4 to 20 mm inclusive. The displaced material to each side...
1990
English
Product grade A washers with a hardness up to 250 HV designed for use with hexagon head bolts and nuts
This standard specifies requirements for product grade A washers with a hardness up to 250 HV, designed for use with bolts of properly class 8.8 or less. The preferred application of these washers is in product grades A and B hexagon head bolt/hexagon nut assemblies, with widths acoss flats as sp...