Check out other specifications
2003
English
Fasteners—Acceptance inspection
This Standard specifies the acceptance inspection procedure that the purchaser of fasteners must follow in order to determine whether a lot of fasteners will be accepted or rejected in cases where no other such procedure was agreed with the supplier at the time the fasteners were ordered. Additio...
1999
English
BLIND RIVETS GLOSSARY OF TERMS
This glossary presents preferred nomenclature and definitions of terms relating to blind rivets. It is intended that this glossary serve as a guide to users and producers to assist them toward the use of a single system of terminology for the characteristics and properties of blind rivets and ot...
1980
English
Slotted head machine screws for precision instruments
This Japanese Industrial Standard specifies the steel slotted head machine screws, herein after referred to as the "steel machine screws", brass slotted head machine screws, hereinafter referred to as the " brass machine screws", and stainless steel slotted head machine screws, hereinafter referr...
2004
English
Parallel screw thread gauges— Measuring method of gauges
This Japanese Industrial Standard specifies measuring method of screw thread plug gauges and ring gauges (hereafter referred to as “thread gauges”) among limit gauges for parallel screw threads having single-start thread with symmetrical ridge defined in JIS B 0251, JIS B 0254 or JIS B 0255 and o...
1992
English
Hexagon nuts, style 1 – Product grades A and B (ISO 4032 :1986) English version of DIN EN 24032
This International Standard gives specifications for hexagon nuts, style 1, with thread diameters from M1,6 to M64 inclusive, with product grade A for sizes d < M16 and product grade B for sizes d > M16.
1985
English
Flake graphite cast iron (grey cast iron) Properties
In conjunction with the general technical delivery conditions specified in DIN 1690 Part 1, this standard specifies the properties of carbon and low alloy flake graphite cast iron (grey cast iron) in castings manufactured in sand moulds or moulds of comparable thermal diffusivity. The following c...
4.01