DIN 928
Square weld nuts
English
2000
0.000
Detailed Information
This standard specifies requirements for sizes M4 to M16 coarse and fine pitch thread square weld nuts of product grade A, for use with bolts of property classes below 8.8 as specified in DIN EN ISO 898-1.
Download File
(Log in to download spec.)
Check out other specifications
1987
English
Hexagon nuts with metric coarse and fine pitch thread – Product classes A and B
This standard specifies requirements for M1 to M160 hexagon nuts, assigned to product grade A (up to size M16) or product grade B (for sizes above M16). lf, in special cases, nuts are to comply with specifications other than those given in this standard, e.g. regarding property class, they shall ...
2008
English
ALLOY STEEL SOCKET-HEAD CAP SCREWS
1.1 This specification covers the requirements for quenched and tempered alloy steel hexagon socket-head cap screws, 0.060 through 4 in. in diameter where high strength is required. 1.2 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are includ...
2011
English
Fasteners – Ends of parts with external ISO metric thread
This International Standard specifies the form and dimensions of ends of parts with external ISO metric screw thread (e.g. bolt, screw and stud ends) recommended for use. They apply to standardized or non-standardized threaded parts. For each end type, a symbol is specified and it is intended th...
1991
English
Fasteners – Surface discontinuities – Bolts, screws and studs subject to special requirements (ISO 6157 -3 : 1988) (English version of DIN EN 26 157 Part 3)
This part of ISO 6157 establishes limits for various types of surface discontinuities on bolts, screws and studs for special requirements. It applies to bolts. screws and studs with - nominal thread diameters 5 mm and larger; - product grades A and B; - nominal lengths l < 10d (or longer if spec...
1991
English
Standard Specification for Stainless Steel Socket Button and Flat Countersunk Head Cap Screws [Metric]
1.1 This specification covers the chemical and mechanical requirements for stainless steel metric hexagon socket button (SBHCS) and flat countersunk (SFHCS) head cap screws with nominal thread M 3 through M 20 intended for use in applications requiring general corrosion resistance. 1.2 Two proper...
1981
German
Mechanische Verbindungselemente – Technische Lieferbedingungen – Aufweitversuch für Muttern
1 Geltungsbereich Diese Norm ergänzt DIN 267 Teil 1 und Teil 4, sowie DIN lSO 898 Teil 2 und enthält Festlegungen über einen Aufweitversuch für Muttern mit Festigkeitsklassen nach DIN ISO 898 Teil 2 und DIN 267 Teil 4 mit Gewindedurchmessern von 3 bis 39 mm. 2 Zweck Der Aufweitversuch nach diese...