Check out other specifications
1986
English
Knurled thumb screws
The following amendments have been made in comparison with the December 1970 edition of the present standard and the December 1970 edition of DIN 465. a) DIN 464 and DIN 465 have been combined into one standard. b) Symbol Sz has been included for the slotted design as specified in DIN 962. c) The...
2002
English
STRUCTURAL BOLTS, STEEL, HEAT TREATED, 120/105 KSI MINIMUM TENSILE STRENGTH
1.1 This specification covers two types of quenched and tempered steel heavy hex structural bolts having a minimum tensile strength of 120 ksi for sizes 1.0 in. and less, and 105 ksi for sizes over 1.0 to 1-1/2 in., inclusive. 1.2 The bolts are intended for use in structural connections. These co...
2007
English
PREVAILING-TORQUE TYPE STEEL HEX AND HEX FLANGE NUTS REGULAR AND LIGHT HEX SERIES
This standard establishes the dimensional, mechanical and performance requirements for three grades of prevailing-torque type steel hex nuts, in sizes No.4 thru 1-1/2 in., and two grades of prevailing-torque type steel hex flange nuts, in sizes 1/4 thru 3/4 in.
1993
English
Threaded fasteners — Axial load fatigue testing — Test methods and evaluation of results
This International Standard specifies the conditions for carrying out axial load fatigue tests on threaded fasteners, as well as recommendations for the evaluation of the results. Unless otherwise agreed, the tests are of the fluctuating tension type and are carried out at room temperature, the ...
1992
English
Slotted set screws with cone point (ISO 7434 : 1983) English version of DIN EN 27 434
This International Standard specifies the characteristics of slotted set screws with cone point and thread sizes from M 1,2 to M 12 inclusive and product grade A.