This standard is limited to dimensions and capacities for forged threaded eyebolts intended primarily for lifting applications, and covers the following types and styles. Type 1, Plain pattern (straight shank) (see Table 1) Style A, Long length Style B, Short length Type 2, Shoulder pattern (se...

This standard specifies M 6 to M 48 T·head bolts with square neck. They are designed for use in attaching components to foundations or similar structures by means of T·slots (such as are specified in DIN 649), where T·head bolts with square neck are considered adequate detachable fasteners.

This standard specifies requirements for external tab washers (previously known as locking tab washers), which are used in threaded fastenings. They are intended to prevent the fastening loosening off. The washer's effectiveness depends on the design conditions of the particular case and on the l...

This standard specifies requirements for M 10 to M 12 square nuts assigned to product grade C. See DIN 962 (or the standards referred to therein) for special nut types or finishes. If, in special cases, nuts are to comply with specifications other than those given in this standard (e.g. regarding...

This standard outlines a Quality Assurance Plan for internally and externally threaded fasteners and accessories or associated parts. Provisions are included for sampling plans, inspection frequencies, control procedures, record keeping and disposition of nonconforming materials and parts. The ba...

This quality focused Standard establishes in-process and final inspection requirements for fastener products as well as a receiving inspection plan for fastener purchasers. This Standard identifies four categories, recognizing that fastener users have widely varying requirements. The four categor...