IFI-505
METRIC BREAK MANDREL BLIND RIVETS
English
1999
0.000
Detailed Information
This standard establishes the dimensional, mechanical, and performance requirements of metric break mandrel blind rivets
suitable for use in joining the component parts of an assembly.
Download File
(Log in to download spec.)
Check out other specifications
2002
English
SURFACE DISCONTINUITIES OF BOLTS, SCREWS, AND STUDS
This specification establishes allowable limits for the various types of surface discontinuities that may occur during the manufacture and processing of bolts, screws, and studs. including heat treated machine screws, tapping screws, and SEMS (the washers of screw-washer assemblies are excluded)....
2004
English
Hexagon nuts and hexagon thin nuts
This Japanese Industrial Standard has been prepared based on the third edition of ISO 4032 : 1999 Hexagon nuts, style 1-Product grades A and B published in 1999, the second edition of ISO 4033 Hexagon nuts, style 2-Product grades A and B published in 1999, the third edition of ISO 4034 Hexagon nu...
2000
English
Hexagon weld nuts
This standard specifies requirements for sizes M3 to M16 coarse and fine pitch thread hexagon weld nuts of product grade A, for use with bolts of property classes below 8.8 as specified in DIN EN ISO 898-1. Hexagon weld nuts with flange are specified in DIN 977.
1993
English
TAPPING SCREW APPROXIMATE HOLE SIZES
The approximate hole sizes set forth on the following pages are intended to provide general guidance to the user in selecting holes for installing the respective types of thread forming and thread cutting tapping screws in various commonly used materials. It should be noted, however, that because...
1992
English
Half-length taper grooved pins (ISO 8745 : 1986) English version of DIN EN 28 745
This International Standard specifies the characteristics of half-length taper grooved pins which have three equally spaced grooves impressed longitudinally on their exterior surface, with metric dimensions and nominal diameter, d1, from 1,5 to 25 mm inclusive. The displaced material to each sid...
1994
English
Mechanical properties of fasteners – Nuts with coarse pitch thread and specified proof load values (ISO 898-2 : 1992) English version of DIN EN 20898 Part 2
This International Standard specifies the mechanical properties of nuts with specified proof load values when tested at room temperature (see ISO 1). Properties will vary at higher and lower temperature.