ISO 12683
Mechanically deposited coatings of zinc — Specification and test methods
English
2004
0.000
Detailed Information
This document specifies the requirements for coatings of zinc that have been mechanically deposited on to fabricated metal articles to protect them from corrosion. It also describes the related test methods.

Download File
(Log in to download spec.)
Check out other specifications
1990
English
METRIC PLAIN WASHERS
This standard covers general specifications and dimensions for flat, round hole washers, both soft (as fabricated) and hardened, intended for use in general purpose applications. The inclusion of dimensional data in this standard is not intended to imply that all sizes displayed are production st...
1999
English
Fasteners — Preloading test for the detection of hydrogen embrittlement — Parallel bearing surface method
This International Standard specifies a preloading test which is able to detect the occurrence of hydrogen embrittlement of fasteners at room temperature. This test is applicable to — metric bolts, screws and studs; — thread rolling screws; — self-tapping screws; — self-drilling screws; — nuts; ...
1998
English
Hexagon bolts with flange – Heavy series – English version of DIN EN 1665
This European Standard specifies characteristics of hexagon bolts with flange, heavy series, with threads from M5 up to and including M20 and with property classes 8.8, 10.9 and A2-70.
1997
English
Standard Specification for Style 1 Stainless Steel Metric Nuts
1.1 This specification covers the chemical and mechanical requirements for stainless steel metric nuts with nominal thread diameters M1.6 through M36, and intended for use in engineering applications requiring general corrosion resistance. 1.2 Eight groups of stainless steel alloys are covered, i...
2008
English
FINISH SPECIFICATION
The following specifications cover requirements for finishes used on Worldwide Standard and Utility Parts. NOTE: Obsolete finish specifications are not shown in this standard. If a finish is referenced that is not shown in this standard, the user should contact the local Fastener Engineering Offi...