JIS B 0147
Blind rivets—Terminology and definitions
English
2004
0.000
Detailed Information
This Standard specifies the terminology and definitions for types, performance characteristics and geometry for blind rivets and the terminology for blind rivet setting and setting equipment used generally in blind riveting.
Download File
(Log in to download spec.)
Check out other specifications
1995
English
Studs – with a length of engagement equal to about 2,5 d
This standard specifies dimensions and technical delivery conditions for studs intended for use mainly in light metals of low strength. As specified in DIN 267-2, the stud end thread shall be produced to tolerance Sk6 as in DIN 13-51, unless the stud is designated Fo (‘without interference-fit th...
1998
English
THREAD FORMING AND THREAD CUTTING TAPPING SCREWS AND METALLIC DRIVE SCREWS
This standard covers the complete general and dimensional data for the various types of slotted and recessed head tapping screws and metallic drive screws recognized as "American National Standard." Also included are appendixes which provide specifications and instructions for protrusion gaging o...
1996
English
PLOW BOLTS (INCH SERIES)
1.2.1 This standard recommends Table 1, No. 3 square neck, 80 deg round countersunk head and Table 2, No. 7 reverse key, 60 deg round countersunk head plow bolts for new designs. It includes No. 3 square neck, round countersunk repair head; Table 3, No. 4 countersunk, square repair head; Table 4,...
1999
English
COATING, OXIDE, BLACK, FOR FERROUS METALS
This specification covers black oxide coatings applied to ferrous metals (wrought iron, carbon, low alloy, and corrosion resistant steels). Black oxide coatings, with or without a supplementary preservative treatment (see 3.11), may be used where a black surface is required. Only very limited cor...
2004
English
Blind rivets—Terminology and definitions
This Standard specifies the terminology and definitions for types, performance characteristics and geometry for blind rivets and the terminology for blind rivet setting and setting equipment used generally in blind riveting.
2006
German
Stähle und Nickellegierungen für Befestigungselemente für den Einsatz bei erhöhten und/oder tiefen Temperaturen; Deutsche Fassung EN 10269:1999 + A1:2006
Diese Europäische Norm EN 10269 legt die Anforderungen an Halbzeug, Stäbe und Draht für Befestigungselemente für den Einsatz bei erhöhten und/oder tiefen Temperaturen aus unlegierten und legierten (einschließlich nichtrostenden) Stählen und Nickellegierungen nach Tabelle 1 fest. Bei Lieferungen ...