JIS B 0205-2

ISO general purpose metric screw threads — Part 2: General plan

English 2001

0.000

Detailed Information

This Standard specifies ISO general purpose metric screw threads (M) having basic profile according to JIS B 0205-1. Basic dimensions are given in JIS B 0205- 4. For tolerances see JIS B 0209-1.

Download File

(Log in to download spec.)

Check out other specifications

DIN EN

DIN EN 10130

1991

English

Cold rolled flat steel products for cold forming – Technical delivery conditions – English version of DIN EN 10130

This European Standard applies to cold rolled non-coated low carbon steel flat products in rolled widths equal to or over 600 mm for cold forming, with a minimum thickness of 0,35 mm, and unless otherwise agreed at the time of ordering, equal to or less than 3 mm, delivered in sheet, coil, slit c...

ASTM

ASTM A574

1998

English

Standard Specification for Alloy Steel Socket-Head Cap Screws

1.1 This specification covers the requirements for quenched and tempered alloy steel hexagon socket-head cap screws, 0.060 through 4 in. in diameter where high strength is required. NOTE 1-A complete metric companion to Specification A 574 has been developed-A 574M; therefore no metric equivalent...

ISO

ISO 965-1

1980

English

ISO general purpose metric screw threads – Tolerances – Part 1 : Principles and basic data

This International Standard specifies a tolerance system for screw threads conforming to ISO 261, ISO general purpose metric screw threads - General plan. The tolerance system refers to the basic profile according to ISO 68, ISO general purpose screw threads - Basic profile.

ASTM

ASTM F2280

2008

English

“TWIST OFF” TYPE TENSION CONTROL STRUCTURAL BOLT/NUT/WASHER ASSEMBLIES, STEEL, HEAT TREATED, 150 KSI MINUMUM TENSILE STRENGTH

1.1 This specification covers two types of heat treated, steel, tension control bolt-nut-washer assemblies, also referred to as "sets," having a tensile strength of 150 to 173 ksi. These assemblies are capable of developing a minimum predetermined tension when installed by applying torque to the ...

ASTM

Abstract of ASTM A325

2002

English

STRUCTURAL BOLTS, STEEL, HEAT TREATED, 120/105 KSI MINIMUM TENSILE STRENGTH

1.1 This specification covers two types of quenched and tempered steel heavy hex structural bolts having a minimum tensile strength of 120 ksi for sizes 1.0 in. and less, and 105 ksi for sizes over 1.0 to 1-1/2 in., inclusive. 1.2 The bolts are intended for use in structural connections. These co...

DIN EN

DIN EN 22340

1992

English

Clevis pins without head (ISO 2340 : 1986) English version of DIN EN 22 340

This International Standard specifies the characteristics of clevis pins without head, with metric dimensions and nominal diameters, d, from 3 to 100 mm inclusive.