JIS B 0209-1

ISO general purpose metric screw threads – Tolerances – Part 1: Principles and basic data

English 2001
0.000
JIS
Detailed Information

This Standard specifies the tolerance system for ISO general purpose metric screw threads (M) conforming to JIS B 0205-2.

The tolerance system refers to the basic profile in accordance with JIS B 0205-1.

Download File
(Log in to download spec.)

Check out other specifications

BS EN ISO
BS EN ISO 286-2
2010
English

Geometrical product specifications (GPS) — ISO code system for tolerances on linear sizes – Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts (ISO 286-2:2010)

This part of ISO 286 gives values of the limit deviations for commonly used tolerance classes for holes and shafts calculated from the tables given in ISO 286-1. This part of ISO 286 covers values for the upper limit deviations ES (for holes) and es (for shafts), and the lower limit deviations EI...
IFI
IFI-117
2008
English

PULL THROUGH MANDREL BLIND RIVETS

This standard establishes the dimensional, mechanical, and performance requirements for inch series pull through mandrel blind rivets suitable for use in engineering assemblies where load transmitting capability by the rivet is a design requirement. A metric series counterpart standard is in exis...
ISO
ISO 7721
1983
English

Countersunk head screws – Head configuration and gauging

This International Standard specifies the Characteristics of head configurations of slotted and recessed countersunk head screws, and recommends a gauging method for the head dimensions laid down in the respective product standards.
MIL
MIL-DTL-18240F
1997
English

FASTENER ELEMENT, SELF-LOCKING, THREADED FASTENER, 250°F MAXIMUM

This specification defines the requirements for self-locking elements for use in externally threaded fasteners such as bolts and screws to be used in fasteners with either UNC, UNJC, UNF, UNJF, UNRC or UNRF threads and where the temperatures will not exceed 250°F.
DIN
DIN 6926
1983
English

Prevailing torque type hexagon nuts with flange and with non-metallic insert

This standard gives specifications for prevailing torque type hexagon nuts with flange and with non-metallic insert, with metric thread with diameters from 5 to 20 mm, assigned to product grade A. If, in special cases, nuts are to comply with specifications other than those given in this standar...
ISO
ISO 7719
1983
English

Prevailing torque type all-metal hexagon nuts, style 1 – Property classes 5, 8 and 10

This International Standard specifies the characteristics of prevailing torque type all-metal hexagon nuts with thread sizes from M 5 to M 36 inclusive, in property classes 5, 8 and 10, and product grades A (d ≤ M 16) and B (d > M 16).