Check out other specifications
2000
English
HARDENED STEEL WASHERS
This specification covers the chemical, mechanical, and dimensional requirements for hardened steel washers for use with fasteners having nominal thread diameters of 1/4 through 4 in. These washers are intended for general purpose mechanical and structural use with bolts, nuts, studs, and other i...
1998
English
Standard Specification for Alloy Steel Socket-Head Cap Screws [Metric]
1.1 This specification covers the requirements for quenched and tempered alloy steel socket-head cap screws 1.6 mm through 48 mm in diameter having a minimum ultimate tensile strength of 1220 MPa.
2002
English
INSPECTION AND QUALITY ASSURANCE FOR SPECIAL PURPOSE FASTENERS
This standard outlines a Quality Assurance Plan for internally and externally threaded fasteners and accessories or associated parts. Provisions are included for sampling plans, inspection frequencies, control procedures, record keeping and disposition of nonconforming materials and parts. The ba...
1983
English
High strength hexagon fit bolts with large widths across flats for structural steel bolting
This standard specifies high strength hexagon fit bolts with large widths across flats. Fit bolts are intended for use in structural steel bolting (GVP bolting or SLP bolting). They may only be used together with hexagon nuts complying with DIN 6915 and with washers complying with DIN 6916, DIN 6...
1988
English
Hexagon socket head shoulder screws
This Japanese Industrial Standard specifies the steel hexagon socket head shoulder screws used generally, hereinafter referred to as the "screws". However, the screws to be used for holding stripper of press dies may be in accordance with JIS B 5064, as required.
1999
English
PIN, STRAIGHT, HEADLESS (DOWEL) (.0002 OVER NOMINAL SIZE)
CARBON OR ALLOY STEEL PINS SHALL HAVE A CORE HARDNESS OF 47-58 HRC, AND A CASE HARDNESS OF 60 HRC MINIMUM. THE CORE HARDNESS OF THE PINS SHALL NOT IN ANY INSTANCE EXCEED THE CASE HARDNESS. MINIMUM PENETRATION FOR THE CASE HARDNESS SHALL NOT BE LESS THAN .020 INCH. PINS 1/16 INCH AND LESS IN DIAME...
