JIS B 1117
Slotted set screws
English
1995
0.000
Detailed Information
This Japanese Industrial Standard specifies the steel made slotted set screws (hereafter, referred to as “steel set screws”), and stainless steel made set screws (hereafter, referred to as “stainless steel set screws” ) for general use.
Download File
(Log in to download spec.)
Check out other specifications
1960
English
Cycle threads
This standard covers the threads to be used for bicycle, rear cart and the other similars.
1999
English
METRIC PULL THROUGH MANDREL BLIND RIVETS
This standard establishes the dimensional, mechanical, and performance requirements of metric pull through mandrel blind rivets suitable for use in engineering assemblies where load transmitting capability by the rivet is a design requirement.
1990
English
Square taper washers for high-strength structural bolting of steel channel sections
Washers as specified in this standard are intended for use in GV and SL structural bolting of steel channel sections in accordance with DIN 18 800 Part 1, together with DIN6914 bolts and DIN6915 nuts.
2008
English
“TWIST OFF” TYPE TENSION CONTROL STRUCTURAL BOLT/NUT/WASHER ASSEMBLIES, STEEL, HEAT TREATED, 120/105 KSI MINIMUM TENSILE STRENGTH
1.1 This specification covers two types of heat treated, steel, tension control bolt-nut-washer assemblies, also referred to as “sets." These assemblies are capable of developing a minimum predetermined tension when installed by applying torque to the nut, while at the same time applying a counte...
1995
English
Self-drilling tapping screws – Dimensions, requirements and testing
This standard specifies dimensions. requirements and test methods for heat-treated self-drilling tapping screws ('tapping screws' for short). These screws have a drill point with which they form a pilot hole during assembly, followed by a threaded section with which they form their mating thread,...
2006
English
High-strength structural bolting assemblies for preloading – Part 4: System HV – Hexagon bolt and nut assemblies – English version of DIN EN 14399-4:2006-06
This document specifies together with EN 14399-1 the requirements for assemblies of high-strength structural bolts and nuts of system HV suitable for preloaded joints with large widths across flats, thread sizes M 12 to M 36 and property classes 10.9/10. Bolt and nut assemblies to this document ...