IFI-520

METRIC PULL THROUGH MANDREL BLIND RIVETS

English 1999
0.000
IFI
Detailed Information

This standard establishes the dimensional, mechanical, and performance requirements of metric pull through mandrel blind
rivets suitable for use in engineering assemblies where load transmitting capability by the rivet is a design requirement.

Download File
(Log in to download spec.)

Check out other specifications

BS EN
BS EN 10025-3
2004
English

Hot rolled products of structural steels — Part 3: Technical delivery conditions for normalized/normalized rolled weldable fine grain structural steels

Part 3 of this document, in addition to part 1, specifies requirements for flat and long products of hot rolled weldable fine grain structural steels in the normalized/normalized rolled delivery condition in the grades and qualities given in Tables 2 to 4 (chemical composition) and Tables 5 to 7 ...
ASTM
Abstract of ASTM F1136
1993
English

CHROMIUM/ZINC CORROSION PROTECTIVE COATINGS FOR FASTENERS

1.1 This specification covers the basic requirements for three grades of chromium/zinc inorganic coatings for threaded fasteners. 1.2 These coatings are applied by conventional dip-spin or dip·drain methods. 1.3 The coating process does not induce hydrogen embrittlement, providing that the fasten...
DIN
DIN 434
1990
English

Square taper washers for use with channel sections

Washers as specified in this standard are intended for use in structural bolting of channel sections using bolts up to property class 5.6.
ASME
ASME B18.5
1998
English

ROUND HEAD BOLTS (INCH SERIES)

This standard covers the complete general and dimensional data for the various types of inch series bolts generally classified as round head bolts and recognized as American National Standard. Also included is an appendix covering gages and gaging for checking bolt straightness.
DIN
DIN 59370
1978
English

Steel Sections – Bright Square Edge Equal Angles – Dimensions, Permissible Deviations, Weights

This Standard applies to bright square edge angles with equal legs, in the dimension range specified in Table 1 and made from the steel grades quoted in Section 5.
ISO
ISO 7719
1983
English

Prevailing torque type all-metal hexagon nuts, style 1 – Property classes 5, 8 and 10

This International Standard specifies the characteristics of prevailing torque type all-metal hexagon nuts with thread sizes from M 5 to M 36 inclusive, in property classes 5, 8 and 10, and product grades A (d ≤ M 16) and B (d > M 16).