Check out other specifications
2010
English
STEEL DRILL SCREWS FOR THE APPLICATION OF GYPSUM PANEL PRODUCTS OR METAL PLASTER BASES TO STEEL STUDS FROM 0.033 IN. (0.84 mm) TO 0.112 IN. (2.84 mm) IN THICKNESS
1.1 This specification covers minimum requirements for steel drill screws for use in fastening gypsum panel products or metal plaster bases to steel members from 0.033 in. (0.84 mm) to 0.112 in. (2.84 mm) in thickness. 1.2 This specification also covers physical properties and test methods for d...
1999
English
Taper pipe threads
This Standard specifies taper pipe threads and is applicable to the threads used mainly for pressure-tight joints on the threads for jointing the pipes, pipe fittings, fluid machinery, etc. The taper pipe thread of PT 3-1/ 2 and PT 7 to PT 12 in thread designation and the parallel pipe thread of...
1998
English
Hexagon bolts with flange – Small series (ISO/DIS 15071 : 1996, modified) English version of DIN EN 1662
This European Standard specifies the characteristics of hexagon flange bolts, small series, with threads from M5 up to and including M16 and with property classes 8.8, 10.9 and A2-70.
1999
English
Mechanical properties of fasteners made of carbon steel and alloy steel — Part 5 : Set screws and similar threaded fasteners not under tensile stresses
This Standard specifies the mechanical properties of set screws and similar threaded fasteners not under tensile stresses with nominal thread diameters from 1.6 mm up to and including 24 mm, which are made of carbon steel or alloy steel (hereafter referred to as “set screws”). The mechanical and...
2009
English
Thread rolling screws for ISO metric thread – Part 1: Technical delivery conditions for case hardened and tempered screws
This standard specifies requirements for case hardened and tempered metric thread rolling screws with various forms of head geometry designed to produce internal threads with nominal diameters from 2 mm to 12 mm, which fit general purpose ISO metric screw threads and are used in general engineeri...
1995
English
Self-drilling tapping screws – Dimensions, requirements and testing
This standard specifies dimensions. requirements and test methods for heat-treated self-drilling tapping screws ('tapping screws' for short). These screws have a drill point with which they form a pilot hole during assembly, followed by a threaded section with which they form their mating thread,...