MIL-A-8625F

ANODIC COATINGS FOR ALUMINUM AND ALUMINUM ALLOYS

English 1993
0.000
MIL
Detailed Information

This specification covers the requirements for six types and two classes of electrolytically formed anodic coatings on aluminum and aluminum alloys for non-architectural applications.

Download File
(Log in to download spec.)

Check out other specifications

DIN
DIN 7996
1986
English

Cross recessed pan head wood screws

As a departure from DIN 7996, March 1975 edition (which was withdrawn in December 1984), the present edition specifies a second type of cross recess, viz. cross recess type Z, also referred to in practice as Pozidriv recess.
ASTM
ASTM F2437
2006
English

CARBON AND ALLOY STEEL COMPRSSIBL-WASHER-TYPE DIRECT TENSION INDICATORS FOR USE WITH CAP SCREWS, BOLTS, ANCHORS, AND STUDS

1.1 This specification covers the requirements for carbon and alloy steel compressible-washer-type direct tension indicators capable of indicating a specified bolt tension in cap screws, bolts, anchors, and studs. 1.2 Direct tension indicators in nominal diameter sizes 1/4 through 2-1/2 in. are c...
DIN
DIN 6923
1983
English

Hexagon nuts with flange

This standard gives specifications for hexagon nuts with flange, with metric coarse or fine thread with diameters from 5 to 20 mm, assigned to product grade A. If, in special cases, nuts are to comply with specifications other than those given in this standard, e.g. regarding property classes, th...
DIN
DIN 553
1986
English

Slotted set screws with cone point (modified version of ISO 7434, 1983 edition )

This standard specifies the characteristics of M 1 to M 12 slotted set screws with cone point, assigned to product grade A. Where, for special purposes, the screws are to meet requirements differing from those specified in the present standard, e.g. in respect of material (hardness class) or inte...
ASTM
ASTM A480/A480M
2008
English

Standard Specification for General Requirements for Flat-Rolled Stainless and Heat-Resisting Steel Plate, Sheet, and Strip

1.1 This specification covers a group of general requirements that, unless otherwise specified in the purchase order or in an individual specification, shall apply to rolled steel plate, sheet, and strip, under each of the following specifications issued by ASTM: Specifications A 167, A 176, A 24...
IFI
IFI-135
2008
English

MECHANICAL TESTING OF BLIND RIVETS

1.1 Scope. This standard describes procedures for the mechanical testing of inch series blind rivets to determine properties required in the product standard. 1.2 The following tests are described: Shear strength, Para. 2.1 Tensile strength, Para. 2.2 Mandrel break load, Para. 2.3 Blind head form...