[drts-entity]
Check out other specifications
1993
English
NONFERROUS BOLTS, HEX CAP SCREWS, AND STUDS FOR GENERAL USE [METRIC]
1.1 This specification covers the requirements for commercial wrought nonferrous bolts, hex cap screws, and studs in nominal thread diameters M6 to M36 inclusive manufactured from a number of alloys in common use and intended for general service applications. 1.2 Unless otherwise specified, nuts ...
2003
English
Tolerances for fasteners — Part 1 : Bolts, screws, studs and nuts — Product grades A, B and C
This Standard specifies a selection of tolerances for bolts, screws, studs and nuts with ISO metric threads and with product grades A, B and C and for tapping screws with product grade A.
2010
English
CARBON AND ALLOY STEEL NUTS FOR BOLTS FOR HIGH PRESSURE OR HIGH TEMPERATURE SERVICE, OR BOTH
1.1 This specification covers a variety of carbon, alloy, and martensitic stainless steel nuts in the size range 1/4 through 4 in. nominal. It also covers austenitic stainless steel nuts in the size range 1/4 in. nominal and above. These nuts are intended for high-pressure or high-temperature ser...
1976
English
Securing Parts for Rolling Bearings – Snap Rings for Bearings with Ring Groove
For connection with DIN 616 and ISO 464, see Explanations. This Standard specifies the dimensions of snap rings required for securing bearing with ring groove according to DIN 616, diameter series 0, 2, 3 and 4.
1995
English
Studs
This Japanese Industrial Standard specifies the steel studs for general use (hereafter referred to as "bolts").
2000
English
Standard Specification for Steel Sheet, Zinc-Coated (Galvanized) or Zinc-Iron Alloy-Coated (Galvannealed) by the Hot-Dip Process
1.1 This specification covers steel sheet, zinc-coated (galvanized) or zinc-iron alloy-coated (galvannealed) by the hot-dip process in coils and cut lengths. 1.2 The product is produced in various zinc or zinc-iron alloy-coating weights [masses] or coating designations as shown in Table 1. 1.3 Pr...